6 Easy Steps To Remove Glued Wooden Dowels
Here are some of the steps by which the customers can easily Remove the Glued Wooden Dowels:
- Gather All The Tools And Materials: The customers need to start by gathering all the tools and the materials they require while performing this procedure like electric drill, drill bit, syringe, warm water, alcohol, vinegar, Awl, hammer, sanding tool, and the Heat Gun.
- Use The Electric Drill: The customers then need to use the electric drill and then make the even holes in the wood joint by using the half-inch drill bit.
- Use The Syringe: The customers then need to use the syringe and fill it up with the warm water, vinegar, and the alcohol as well and it mostly depends upon the type of the wood glue that the customers are attempting to make it soft. If the customers are not sure about the type of wood glue in the wooden joint they then need to use the awl and then dig out a little amount of the wood glue from the wooden joint. If the customers find out the wood joint consists of the White glue then it can easily break than the epoxy or the urethane glue.
- Inject The Syringe: The customers then need to insert the syringe containing the solvent directly into the wooden hole and then they need to use the soft rag in order to wipe away all the excess solvent from the hole. The customers then need to allow the solvent to sit there for near about twenty minutes.
- Twist The Wood: The customers then need to smoothly Twist the wood in order to lose the wood joint and then easily drag apart the joint. If in case the joint does not move smoothly the customers then need to inject more solvent in the hole and then allow it to further sit there for more 20 minutes.
- Use The Heat Gun: If the customers are still unavailable to remove the joint then they need to use the heat gun and then directly point the heat gun towards the wood joint. When the customers will find out that the wood joint becomes flexible then they need to use the sanding pads and rub it over the corners of the wooden holes. The customers then need to twist the wood joint and then gently drag the dowel from the wood joint.