How To Seal A Painted Table: Proper Procedure Of Sealing A Painted Table

Proper Procedure Of Sealing A Painted Table

Painting the furniture lets the cheaply and easily repurpose a piece or update any of the secondhand furniture. But the paint should be properly sealed top enhance its look and life as well. The proper procedure to seal a painted table is mentioned below:

Wait For The Paint To Dry

Before sealing the painted table wait for at least 3 to 7 days after the last coat of paint is applied before proceeding. This will give the paint enough time to cure, and allowing it to reach the maximum hardness, this is important especially in case of oil and enamel-based paints, although the water, as well as latex paint, dry in a few days as well. If the user will skip this step then table paint will be more prone to peeling as well as chipping.

For Light Colors

For the light colors, simple paste wax is best for white or light-colored painted tables, this is because it creates a tough exterior without interfering with the shade of the finish. To apply the wax, dip a clean cotton cloth into the clear paste wax and then start to apply in an even manner on the entire surface of the table. Leave it dry for about one hour, or the amount of time that is recommended by the manufacturer, after that buff the excess wax away with a clean cloth or electric polisher can also be used. The user needs to feel the tabletop so that to make sure there is no sticky residue. Repeat this process 3 to 4 more times, so that the tough exterior for the tabletop is built.

Darker Colors

The darker colors stand up well to the slight color change that is caused by polyurethane or polyacrylic topcoats. Both of the finish will create a hard topcoat but they may cause a slight dulling of the paint. To start applying, lightly sand the tabletop with the help of a sanding block and then wipe away the dust using a cloth. This is helpful to smooth the surface, be careful not to remove any paint. After that apply a thin coat of a clear of these finishes to the entire tabletop with the help of a foam pad or dense paintbrush. The polyacrylic is actually a water-based, although it can be easily applied over oil-based paint. Let this coat dry for 2 hours, and then sand the table again with the help of 320-grit sandpaper, and also wiping away the dust using a cloth. Repeat the same process 3 to 4 more times to get the toughest finish, but remember to sand between each coat.

Leave The Topcoat To Cure

Wait for at least 48 hours before placing anything on the tabletop, the user must wait for one week before using any cleaners on the tabletop for the best results.