How to Remove Vinyl Tiles from Plywood Floor
The users can easily Remove Vinyl Tiles from Plywood Floor by following the below steps:
- Gather All The Tools And The Materials: The users need to start by gathering all the tools and the materials that they require while performing this procedure like Prybar, woodblock, Utility knife, heat gun, and Five-In-One Tool as well.
- Detach The Baseboards: Detach the baseboards by affixing the wooden block above the surface of the baseboard. Place the flattering side of the prybar over the top of the baseboard and then they need to gently push the pry bar in order to detach the baseboards from the walls.
- Trim The Middle Vinyl Tile: Trim the middle vinyl tile from the floor as the vinyl tiles are usually installed in the perimeter wise and the center area of the vinyl flooring is not glued properly. Trim near about 8 inches aside from the walls so that to keep the trimmed vinyl plank in a parallel way to the room walls.
- Use The Utility Knife: Then the user need to trim the vinyl planks in a small Strips by using the utility knife and then they need to detach all the trimmed strips from the floor by using the pry Bar.
- Use The Five-In-One Tool: If in case the users cannot detach the vinyl tiles from the floor then they need to use the Five-In-One Tool and place the sharp edge of the Five-In-One Tool by the sides of the trimmed vinyl tiles and then detach all the strips carefully
- Use The Heat Gun: Heat gun if in case the users are unable to get a grip on the vinyl tiles. They need to use the heat gun on a low setting mode and then they need to apply the heat to the entire area of the trimmed vinyl tile and they need to gently pull the vinyl tiles.