How To Get Deep Scratches Out Of Wood Table: 2 Best Methods To Get Rid Of Scratches

2 Best Methods To Get Rid Of Deep Scratches From Wood Table

The best methods that a user can apply to remove the deep scratches out of wood table are as follows:

Method 1: Wax Filler Sticks

1. Rub Filler Stick: In this step the user needs to select the color of the stick that closely matches to the wood table, then start rubbing the stick on the affected area in the back forth direction until the Scratches are filled.
2. Rubbing With The Fingers: In this step, the user needs to blend the filler in the affected area with the help of fingers but here the user needs to remember one thing that not to remove too much of the filler from the affected area, carefully get it leveled with the rest of the area.
3. Wipe Away The Excess: Now the user needs to use the clean dry rag to remove the excess filler material from beyond the affected area, to reduce the possibility of adding new scratches the user needs to rub in the direction of the grains but not to rub the filler in the Scratches.
4. Dry: Now let the filler to dry for almost 30 minutes, once it dries it will become hard to touch. Repeat the process if needed.

Method 2: Wax Filler Putty

1. Pre-colored Putty: It is highly advisable to choose the filler that should be the same in color as the wood table. To apply it put some filler according to need on the putty knife and spread it on the affected area, keep adding the filler until the Scratches are filled. In order to level out the filler carefully hold the putty knife horizontally sweep it across the affected area. Use the plastic knife instead of metal one.
2. Scrape Off Excess: In this step the user needs to remove the excess filler before it dries out. In order to do this carefully hold the knife at about 45-degree angle and then drag it across the area. For making the affected area smooth drag in different motions.
3. Dry: Now let the filler to dry for almost 30 minutes depending on the weather conditions, it will feel hard once it dries.
4. Sanding: In order to blend it in the wood, the user now needs to use sandpaper to rub it out, use 180 grit sandpaper. Carefully press the sandpaper against the affected area and start rubbing in the back and forth direction but along the grains of the wood.
5. Wipe Off Excess: Use the damp cloth to wipe out the excess filler, dip the cloth in the lukewarm water but please make sure that it's not fully soaked then start rubbing against the wood.
6. Sealant: Now it's very important to seal the affected area with the help of the polyurethane or another sealant. Use the same sealant that is used in the rest of the table.