How To Install A Rain Diverter On A Roof: Proper Procedure Of Installing A Rain Diverter On A Roof

Proper Procedure Of Installing A Rain Diverter On A Roof

Some of the homes don't have a transitional shelter, which may include a porch or a sturdy overhang, which in turn leave homeowners disclosed to the elements while searching for their keys. A relentless or heavy rainfall or rainstorm may result in a shocking shower down the back & at the same time snow can lead to high-risk or unpredictable, icy steps. Nothing is more irritating & troublesome than having to walk through a waterfall befalling over your roof to reach the front door each & every time it rains. However, there is an easy and inexpensive solution to the problem. Placing or fixing a rain diverter over the entrance makes it extremely easy to control the water flow, which in turn makes entering as well as exiting easier for you and your family. You can install a rain diverter on all types of roofs, which may include shingle roof, metal roof & flat roof. In order to install a rain diverter, you will need to have an access to ladder & few other simple tools & you need to be patient as the process will take nearly one to two hours to complete the job. Go through the below-mentioned steps carefully & install a rain diverter in your home:

• Climb A Sturdy Ladder: First of all, mount or go up a sturdy ladder and find out the second row of shingles adjacent or alongside to the roof edge. Make the shingles less tight or firm and lift them slightly with the help of a pry bar, but make sure not to rip or tear the shingles. Some of the shingles may be difficult to move, remove, or cure. Therefore, you need to apply pressure to the pry bar by tapping the butt with the help of a rubber mallet in order to force the shingles up.
• Slide The Long Side Of The Diverter Under The Shingles: Move the long side of the diverter smoothly underneath the shingles, which in turn leaves the lip of the diverter hanging out. Center the diverter extending directly upwards from the entrance area.
• Lift The Shingles To Nail The Diverter In Place: Raise or elevate the shingles in order to nail the diverter into place. Set the nails at the back of the diverter where the shingles will put or keep the nail holes out of sight. Cover the nails using liquid cement in order to prevent leakage.
• Push Down On The Shingles: Finally, push down on the shingles, taking hold of them in place for at least 10 seconds in order to create a sturdy, protective bond.