Step By Step Procedure & Items Required To Hide Electrical Cords On Carpet
Even at certain times the absolute way to hide the cables and the wires that are mainly used for the electronic gadgets is by hiding them beneath the carpet. The users can easily push the wire beneath the carpet and they can easily use the fish tape that is specifically designed for the carpeting also known as the under-carpet tape and it will easily get this process done. The users can easily hide the electrical cords on the carpet by gathering the below-mentioned materials and then following the below-defined step by step procedure:
Materials Required
- Fish Tape
- Cardboard Scraps
- Masking Tape
Procedure
- Move The Furniture Items: Start by moving all the furnishing items that usually sits over the carpet surface on the destined cable or the wire path. Then the users need to place the furnishing items far away so that these furnishing items will not weight down over the carpet surface within the wire path area.
- Lift The Carpet: Then the users need to lift up one potion at one carpet edge where they are going to feed the wire. They need to pull up the small portion of the carpet and then they need to place the cardboard piece adjacent to the baseboard and the wall if they are dealing with the carpet that is of the wall to wall type and by doing so the users can easily protect up the wall later.
- Lift The Tape: Then they need to lift up one fish tap edge or the under carpet tape in between the pad and the carpet and then guide it within the wire path. If in case the obstruction occurs or in case the users find any difficulty while lifting up the tape at certain points then they need to lift it outwards and then start with the basics. Then they need to keep on pushing down the tape beneath the carpet till it won't get near to its destination at the different carpet side.
- Place Another Cardboard Scrap: After that, the users need to place the other scrap of the cardboard adjacent to the wall where the users will think that the tape will appear beneath the carpet. The users need to keep on pushing the tape till the users won't find it will appear beneath the carpet.
- Affix The Wire: Finally affix the wire specifically to the uncovered tape end or the under carpet tape by simply placing the wire within the hole of the tape and then fasten them by using the masking tape piece. Then they need to lift the tape beneath the carpet to its actual point so that the wire will easily travel within it.