Step By Step Process Of Fixing Uneven Drywall
Regardless of the fact that the drywall on your wall got wet as well as buckled, you have eliminated wallpaper, or the drywall was not installed properly, ridges, depressions, visible seams as well as residue will look unsightly or unattractive in any room. You can fix it using a texturing technique, such as skim coating, which is regarded as one of the best methods when it comes to creating perfectly smooth walls. Uneven drywall can make your walls look unattractive or unsightly. The smallest imperfection in drywall can be anticipated as soon as the wall is painted. Also, imperfections, as well as damage, can occur to walls over time. As soon as you notice uneven drywall, you simply need to take into consideration repairing the uneven drywall before you repaint your walls.
Thing's You Will Need
- 120-Grit Sandpaper
- Sanding Pole
- PVA Primer
- Joint Compound
- Mudding Trough
- 10- To 12-Inch Drywall Knife
Step 1: Sand The Wall Using 120-grit Sandpaper
First of all, you need to sand the wall with the help of 120-grit sandpaper in order to get rid of bumps or residue from wallpaper removal. If you are not able to reach higher places on the wall or to sand the ceiling, then you can use a sanding pole. Make sure to prevent sanding seams where the paper tape is noticeable & perceptible. After you are done with sanding, apply a coat of PVA primer on the wall before allowing it to dry. Polyvinyl acetate is one of the best primer-sealer that will help you in making the surface uniform.
Step 2: All-purpose Joint Compound Powder
Now, take a 5-gallon bucket & combine or put together a batch of all-purpose joint compound powder with water or use the ready-mixed compound. If you blend your own, then it is important to make it the consistency of peanut butter. It should not be pourable & also should stay on your mixing tool without falling off and then move some into a plastic mudding trough.
Step 3: Apply The Compound To Depressions In The Drywall
Next, apply the compound into depressions in the drywall before scraping it flat with the help of a 10- to 12-inch drywall knife. If you notice ridges or visible seams, then apply the joint compound on either side of them before scraping it flat with the adjoining wall. It is important not to make them disappear on the first coat. The number of coats it takes is entirely dependent on how large flaws are they are.
Step 4: Allow The Compound To Dry
Allow the compound to dry, before sanding it lightly. Then, clean the sanding dust off the wall before spreading another coat over a wider area of the wall, and scraping it flat. Allow it to dry, and sand, before applying the third coat. The idea is to cautiously & slowly build up the wall surface as long as it is as high as the highest ridge or seam.
Step 5: Again Sand The Wall Lightly With 120-grit Sandpaper
Keep your knife free of bits of paper as well as a dried joint compound by scraping it at regular intervals on the metal rim of the trough and getting rid of the debris from the mud inside the trough. The debris will make lines on the wall as soon as you scrape, which you may be able to sand off or you may have to add an additional coat to fill them. Sand the wall gently with the help of 120-grit sandpaper after the final coat dries. Prime the wall using PVA primer before you paint it.