How To Replace Wood Paneling With Drywall: Proper Procedure Of Replacing Wood Paneling With Drywall

Proper Procedure Of Replacing Wood Paneling With Drywall

In spite of the fact that you can install the drywall over wood paneling, but still this causes problems, for instance, having to move switch boxes as well as receptacles when it comes to accounting for the extra thickness of the wall. Getting rid of the wood paneling is extremely simple, but it is important to remove paneling before putting drywall on the ceilings. Drywall is available in 4-by-8-foot sheets and is having 1/2-inch thick walls and 5/8-inch thick ceilings. Be extra careful when installing larger pieces of drywall, due to the reason that 5/8-inch sheets weigh 75 pounds, and 1/2-inch sheets is having a weight of 50 pounds.

Step 1: Remove Wood Paneling

Firstly, pull out the wood paneling by prying it away from the wall, with the help of a crowbar. Find out the screw or nail heads before marking the location of each vertical wall stud, if necessary. Trim vertical lines betwixt the studs across the paneling from ceiling to floor, with the help of a power saw. Set the blade in such a way that it is only the thickness of the paneling. This, in turn, will help make it easier to pry away the paneling. Eliminate all screws as well as nails from the wall studs.

Step 2: Apply First Sheet Of Drywall To The Ceiling

Now, spread the first sheet of drywall to the ceiling, but make sure to start at one corner. If necessary, trim the sheet in two in order to make it lighter. Secure the drywall to the ceiling joists every 8 inches with the help of 1 5/8-inch drywall screws. Calculate or compute and trim the next piece of drywall. Use a chalk line in order to create longer cutting lines on the drywall. Move a work knife smoothly along the line, and bend the drywall on the line from the other side in order to break the drywall along the line. Move the knife smoothly to the inside of the drywall break, and the drywall will be separated. Keep doing this as long as the ceiling is covered with drywall.

Step 3: Install The First Piece Of Drywall Against The Wall

Next, install the first piece of drywall in opposition to the wall, in one corner. Use 1 5/8-inch drywall nail in order to secure or affix it to the wall studs every 8 inches. As before, calculate or compute and cut the second piece, and follow the same process as long as all walls are covered. Use drywall saw in order to cut out holes for switch boxes and receptacles, as needed. Apply mesh tape to all drywall joints, making sure to place the tape sticky-side down to the wall. Move your hands smoothly over the tape to ensure it is stuck firmly to the wall.

Step 4: Apply A Layer Of Joint Compound Over The Taped Areas

Take a drywall tray & put joint compound into it before applying a layer of compound over the taped areas with the help of a 6-inch drywall knife. Feather out the compound by spreading it on the wall past the edge of the tape, reducing the thickness as you go. Cover all screws as well as nail heads with the compound before waiting for the compound to dry overnight.

Step 5: Sanding All Compounds Removing Any Bumps Or Ridges

Sand all compounds, removing any bumps or ridges. Spread a second layer of compound over any tape or nail as well as screw heads that are still showing. Wait for it to dry wholly, before sanding again. Apply primer as well as paint.