How To Fix Outdoor Furniture Webbing: Easy Process To Re-Web Outdoor Furniture Like Lawn Chair

Easy Process To Re-web Outdoor Furniture Like Lawn Chair

Do you have an outdoor furniture such as a lawn chair with PVC "webbing" straps that are cracked or damaged because it has been exposed to too much sun, wind, or snow? Maybe you just want to add some newer, more vibrant webbing to freshen it up. The majority of lawn chairs available are constructed to support a sizable amount of weight. But after time, the fabric can start to tear and come apart. Why not replace any broken or damaged parts and simply re-web your lawn chair when it needs a little TLC to keep your lawn chairs looking new and in peak condition? With the right maintenance, lawn chairs can be used for a variety of purposes and last a lifetime.

Step 1: Measure The Existing Webbing

To begin with, measure the existing webbing parts on your lawn chair using your handy measuring tape. Typically, new webbing is offered in rolls with 39 feet of webbing. It might be essential to buy more than one roll for big lawn chairs. Make sure you buy galvanized sheet metal screws and washers if new screws are not already included in the package.

Step 2: Remove The Screws From The Old Webbing

The old webbing's screws must then be taken out and thrown away. Pop rivets are used to affix the webbing to some lawn chairs. The pop rivets should be removed after drilling the rivets with the shortest drill bit feasible. Pop rivets won't be used on the new webbing; instead, screws will be employed.

Step 3: Cut The New Webbing

You must cut the new webbing after removing the screws from the old webbing. To calculate how much new webbing you'll need, measure the old webbing. Use the old webbing as a template to cut a fresh piece by simply stretching it across a flat surface. Weave a fresh strip of webbing into position on the chair and allow it to hang over each side by two inches if the previous webbing is too tattered or stretched to serve as a good template. The new component should then be cut with a pair of scissors.

Step 4: Weave The New Webbing In Place To The Seat Of The Lawn Chair

Lay the new webbing across the seat of the chair, starting at the back, and fasten it to the bottom of the frame. Before driving the screws into the frame, make sure to use washers on each screw and tuck the ends under. Pull the webbing firmly but not so tight that it warps the metal frame until it is fully positioned across the width of the chair seat.

Step 5: Continue Weaving Front-to-Back

Attach the first length of webbing that will run front to back, beginning at the front of the lawn chair, and just weave it in and out over the sections of the new webbing that have previously been attached across the width of the chair. Once all of the seat webbing is in place, attach the end of the webbing to the chair's back.

Step 6: Do The Back Of The Lawn Chair & Test Your Lawn Chair

Follow the same instructions to finish the lawn chair's back once you've finished the seat. After completing the aforementioned processes, test your new lawn chair to ensure the new webbing is firmly in place. So take a seat, put your feet up, and unwind!