Easy Process And Tools Needed To Disassemble Gas Cylinder From Office Chair
The seats on the majority of the chairs, which may also include the office chairs have a tendency to get sink after a few years of use, however, there is no need to worry, due to the fact that you don't need to purchase a new chair. There are most chances that the gas cylinder in the chair is the only part which needs to be replaced. If you are looking to disassemble the gas cylinder from office chair, you simply need to gather the required tools & then go through the below-mentioned step by step process carefully and achieve the desired result of your work:
Tools Needed
- One Rubber Mallet
- One Pipe Wrench Or Vice Grip
- One New Chair Cylinder
Step By Step Process
- Separate The Old Cylinder
First and foremost thing that you need to do is to pull out the old cylinder from the base of the chair. You can easily remove the old cylinder by turning the chair on its side and then gently tap the base away from the chair with the help of rubber mallet. - Tightly Secure The Wrench
Near the top of the old cylinder, you need to tightly secure the wrench and then twist it all the way as long as it releases from the mechanism. If in case you don't have access to a pipe wrench, then you can release the mechanism from the chair simply by unscrewing the main bolts that are on the bottom of the seat. After that, with the help of the rubber mallet again tap the mechanism away from the chair. - Lubrication
If there is trouble in getting the chair apart, then simply apply some lubrication like WD40 to the mechanism and then leave it to sit for a few minutes before trying the process again. However, it is highly advisable to protect the surrounding surfaces as well as the chair fabrics before you apply lubricant. - New One Cylinder
After removing the old chair cylinder properly, you simply need to replace it with the new one. Simply pop up the cylinder in the base of the chair and lift them both at the same time into the mechanism. - Set The Chair
Finally, with utmost care, you need to set the chair in the upright position and then take a seat. Fasten back all parts together.
Important & Useful Tips
- If you want & are looking to re-use the cylinder, then it is important to protect it first, with the help of a rag.
- The cylinder is not screwed on, so loosen it as long as it can be pulled out of the base.
- Be sure that the surface is covered, as well as the floor is protected. And stand back so that the cylinder doesn’t hit the feet.
- If the rubber mallet will not work, then use a hammer. But it is important to remember that the hammer may damage the cylinder, so you need to be extremely careful.