How To Install A Crawl Space Door: Proper Procedure Of Installing A Crawl Space Door

Proper Procedure Of Installing A Crawl Space Door

It is a great addition to have a crawl space in your home, due to the fact that it adds extra storage space, however, without a secure crawl space door, the added storage could be very dangerous or risky. In spite of the fact that this added storage space is likely present in your home, but there are no guarantees that it has a door. This means that children or pets could potentially get inside this dark area. Therefore, it is important to install a crawl space door in order to avoid this problem. Installing a door on the crawl space opening for an under-floor area gives protection against invasion from extreme dirt, debris as well as unwanted inhabitants. You will get water-resistant crawl space doors in solid or vented styles that will get adjusted in standard 24- or 30-inch crawl spaces. If you are looking to install a crawl space door at your home, go through the below-mentioned steps carefully & achieve the desired result of your work:

Measurement: First of all, calculate or compute between the inside faces of the crawl space and take note of the width and height. Then, get a crawl space door composed of polymer or galvanized metal that should be entirely based on your calculations.
Pull Out The Door From The Frame: Now, read or go through the instructions and pull out the door from the frame. Entirely dependent on the style, get rid of the screws at the hinges or pull out the door from the frame by hand.
Place The Frame In The Opening: Next, remove any residual mud or dirt from the inside faces of the opening with the help of a steel putty knife. Then, place the frame in the opening. Using the manufacturer's drilled holes as guides, mark the inside faces of the opening for screw anchors at each hole. Keep the frame at one side.
Set Up A Power Drill: After that, set up a power drill with the help of a 3/16-inch carbide drill bit. Drill one-inch-deep holes at each of your marks. Install a 3/16-by-1-inch anchor in each hole before tapping each anchor with the help of a hammer in order to make sure that the outer ends are even with the inside faces of the opening.
Install The Door Into The Frame: Fix a screw-tip attachment in the drill before replacing the frame in the opening and align the manufacturer's holes using the embed anchors. Install the frame by inserting a 1-inch galvanized screw at each hole. Insert the heads of the screws snug against the face of the frame. Install the door into the frame with the help of a screwdriver or by hand.