How To Fix Bulging Drywall Seams: Step By Step Instructions Of Fixing Bulging Drywall Seams

Step By Step Instructions Of Fixing Bulging Drywall Seams

As soon as the drywall tape loses coherence & connection with the drywall mud, it brings a bulger appearance into existence. Drywall tape loses coherence, due to the reason that it has of lack of water while making. Bulging drywall usually means getting cracks in drywall joints. When two drywalls are securely attached, then the seam of two drywall may bulge, meaning that drywall is sticking out for various reasons.

Tools Needed

• Stud Finder Tool
• Utility Knife Or Other Drywall Cutting Tool
• Drywall Tape & Drywall Screw Gun
• Drywall Screws & Joint Compound
• Drywall Sander
• 150-Grit Sandpaper
• Paint Gun
• Primer
• Paint To Match Your Existing Wall

Step By Step Instructions

• Cut The Damaged Drywall
  First of all, you need to cut the damaged area of the drywall with the help of a utility knife and a jab saw before cutting out the bulge section tape. After that, sand any rough edges before cleaning the area properly.
• Apply Joint Compound
  After sanding the rough edges & cleaning the area, it is time to spread the joint compound over the seam. When it comes to a fastening issue, you need to add some drill screws with the help of a drill machine.
• Stick Mesh Type
  Now, stick mesh tape through the seam where the old tape used to be. Paper tape can also be used before giving a little time for the tape to soak in the moisture.
• Pre-fill The Joint
  Next, pre-fill the joint with the help of a mixture of mud and glue before allowing the mud to be fully set.
• Sand The Area
  After that, smooth the edges with the help of a large knife. Allow it to dry wholly before sanding the area and cleaning it off. Drywall sanding is a pain, however, there are numerous tools that make the process much easier.
• Paint
  Finally, it is time to paint your wall, as painting your wall will help adjust the color of the rest of the wall.

Cause Of Drywall Bulging

Drywall seams bulging takes place or happens when there is a rush, or some mistake has been done in building the walls. There are several reasons that cause drywall bulging & some of the causes are described below:

• Improper Installation Of The Fastener
  Improper installation of fasteners will surely result in bulges. It is highly possible that you may damage the drywall paper if you are driving a fastener in your drywall using the wrong equipment or overdriving it, or if you do not take hold of the drywall board in the drain wall properly. And then moist joint compound wipes out the foundation of the drywall panel. You need to drill into the harmed area before wiping out the swallowed drywall paper. Then, you need to sew up the area using the joining component before repainting the area.
• Water System Damage
  Before fixing the drywall, you need to repair the water system of your houses including leaking pipes or roofs. For the water dripped, you may find out discoloration, and water stains on your wall. Moisture reduces the strength as well as durability of the gypsum, which in turn results in swelling. So, plumbing leaks will result in drywall bulging.
• Inadequate Fastenings
  Selecting the proper fastener is extremely important while building the drywall. If there is not sufficient enough screw to safeguard the drywall, it is one of the many installation problems accountable for the drywall bulging along with the frame.