Step By Step Process To Get Rid Of White Water Mold In A Hot Tub
If you own a hot tub then the white water mold is a very common problem but it must not worry you so much. However, this needs to be solved as soon as possible. A white water mold is basically a number of bacteria that are mixed up with the dead skin cells, beauty products, as well as with the body oil. Clean the hot tub filters and also change them regularly. Besides all this, the user needs to follow the below-mentioned steps for removing the white water mold from the hot tub:
- The first step is to drain out all the water from the hot tub. This is the first thing that the user needs to do in order to remove the infected water.
- After the above step is done then the user needs to scrub the entire surface of the hot tub. It is advisable to spend some more time on the affected spots where the white water mold has already bloomed. Use the appropriate solvent and a hot tub brush to avoid damaging the equipment.
- Remove as well as clean the filters, thoroughly. Before even the water is filled to the hot tub, it has to go from the filters. They are most of the time filled with the debris as well as with the refuse that may be helpful in causing the massive growth of the white water mold in the tub. Cleaning the filters is not just spraying them using clean water. It is important to ensure that the user gives them a good chemical soak, at least once in a while.
- After that, the user needs to clean all the hot tub maintenance tools that may include the hosepipe that is used to refill the hot tub, floats as well as any other thing that user may use.
- Give the hot tub an overdose of the chemicals. It is time to shock the hot tub, using a double or the triple amount of chemical treatment than the normal. This chemical treatment will run throughout all the plumbing of the hot tub to remove any of the white water mold as well as even the potential one. It is important to make sure to use the hot tub chemicals for this job to get the best results. Leave the chemical treatment in the tub for about an hour and then drain out the water from the spa. Refill the tub using fresh clean water and then allow it to run through all the plumbing area of the tub and after that drain it again.
- Refill the tub with the freshwater once again and then repeat the shock process one more time, this time use the normal amount of the chemical treatment as compared to the first one.
- Test the PH value of the water to make sure that it is neither too basic not too acidic. The normal PH value must be in between the 7.0 and 7.5, which is very neutral as well as the perfect for a hot tub.