Proper Procedure Of Replacing Gas Cylinder From Office Chair
The seats on the majority of the chairs, which may also include the office chairs have a tendency to get sink after a few years of use, however, there is no need to worry, due to the fact that you don't need to purchase a new chair. There are most chances that the gas cylinder in the chair is the only part which needs to be replaced. Replacing the old gas cylinder with the new one is extremely easy provided you have the right tools & follow the right technique. You, first of all, need to have all the tool ready before you proceed towards the step by step instructions.
Tools Needed
- Cordless Drill
- Torque Wrench
- Rubber Mallet
- New Gas Cylinder
Step By Step Instructions
- Separate The Old Cylinder
First of all, you need to do is to pull out the old cylinder from the base of the chair. You can easily remove the old cylinder by turning the chair on its side and then gently tap the base away from the chair with the help of rubber mallet. You simply have to position the chair horizontally, putting it on its side. - Tightly Secure The Wrench
Near the top of the old cylinder, you need to tightly secure the wrench and then twist it all the way as long as it releases from the mechanism. If in case you don't have access to a pipe wrench, then you can release the mechanism from the chair simply by unscrewing the main bolts that are on the bottom of the seat. After that, with the help of the rubber mallet again tap the mechanism away from the chair. The base of the chair is usually connected either with retaining clips or nut as well as bolts at its center. You need to get rid of the retaining clips or remove the nuts and bolts with the help of a wrench or drill. Finally, pull out the base of the chair. - Apply Lubricant (WD-40)
If there is trouble in getting the chair apart, then simply apply some lubrication like WD40 to the mechanism and then leave it to sit for a few minutes before trying the process again. However, it is highly advisable to protect the surrounding surfaces as well as the chair fabrics before you apply lubricant. Put down a pipe wrench on the gas cylinder, before spraying it with WD-40 in order to lubricate it and make it easier to remove. Twist as well as pull the wrench in order to loosen the cylinder and remove it from its place. - Replace Old Cylinder With New One
Look up the chair's part number in order to find which gas cylinders are most compatible with your chair. After removing the old chair cylinder properly, you simply need to replace it with the new one. Simply pop up the cylinder in the base of the chair and lift them both at the same time into the mechanism. - Follow The Instructions For Your Specific Gas Cylinder
Due to the fact that the installation procedure may vary, you need to follow instructions for your specific gas cylinder. Position the tapered part of the cylinder into the column before rotating it into place. Reconnect the base of the chair before placing the chair upright as well as adjusting the chair to your preferred height. Finally, test the chair out by sitting on it.