Best And Easy Steps For Installing The Vinyl Plank Flooring On Shower Walls
Shower walls look good in the bathroom that gives stunning look to it and installing vinyl floors to shower walls gives an even more stunning look. If you are wondering how to install the vinyl plank floor on shower walls, don't worry we are here to provide you solution. Follow the given steps in order to install vinyl plank flooring on shower walls:
- Measure The Dimensions: The first important step is to measure the dimensions of the area where the Vinyl Plank Flooring is to be installed. After the measurement is done then estimate how many 1-by-1-foot Vinyl Plank will be needed to fill all the area. Its advisable to buy the extra vinyl plank flooring that will be used incase of any bad cuts or mistakes.
- Level The Area: The second step is to make sure that the surface where the planks are to be installed, should be properly leveled, in case it's not leveled, that time use a hammer or even sandpaper to smooth out and level the surface. The user also needs to make sure that there should be no holes or cracks on the surface where vinyl is to be installed, for any holes fill it and make the area smooth before heading to the process.
- Cleaning: In order to make sure that the Vinyl Plank Flooring adheres properly to the surface so it's important to thoroughly clean the shower area, remove all the dirt or debris being trapped between the surfaces. In case the user has used water for the cleaning process then the area should be properly dry before going for next step.
- First Vinyl Plank: Now in this step the user needs to take the first plank and position it correctly in the right place this will help to make sure it will fit the area, in case its fir then peel off the backing that is meant for adhesive and carefully fix into the place. Press firmly on the plank in all directions so that it adheres well to the surface. The user can use the tile roller or rolling pin to remove any air bubbles from underneath of the tile.
- Other Plank: After the first plank is installed, then move on to another one, the important point here is to make sure that the edges of the vinyl tiles line up correctly with each other. In the case of patterns, it should properly line up to make the correct pattern. In some points the user needs to cut the planks that use the cardboard as template of the area than trace out the template on the plank and cut with a utility knife.
- Examine: Once all the job is done then its time to examine the work to make sure they have been firmly pressed into space. If any trouble is found, then use the tile roller or rolling pin to roll firmly on the affected area.