Proper Procedure To Install Bifold Doors Over Carpet
Bifold doors are dependent on pivot pins at the top as well as the bottom of the external doors. The lower pins are secured into jamb brackets that join or fasten at the floor as well as the face of the doorjambs at each side of the doorway. It is important that the brackets are placed or fixed securely in order to make sure that the undersides of the doors don't swing in or out when used. Placing or fixing jamb brackets on hardwood or tile floors is done with the help of the suitable fasteners. On carpet, experts use wood blocks as attachment platforms for the brackets.
Installing The Top Track
- Bifold doors are exceptional for closets, pantries as well as laundry areas, due to the reason that they give you full access to the contents all at the same time. Sliding doors only allow you to see half of what is in there at one time.
- Installing bifold doors is an easy task and you can complete this task in only an hour. The top track of the kit needs to be centered on the header of the closet. Taking hold of the track in place, a mark can be made with the help of a pencil where the screws will be installed.
- Then, using a size smaller bit in comparison to the screws, pilot holes can be made into the header. This will make it extremely easy to screw in the track while trying to take hold of it into place. As soon as the track is screwed into place, move the pivot brackets smoothly ¼ inch from the frame.
Installing The Bottom Pivot Brackets
- A plumb bob can be used in order to show where the underside pivot brackets will need to be mounted. From the top pivot bracket the plumb bob is attached in order to discover the center of the underside bracket over a wood pad.
- Use a piece of wood that is having the exact height at the carpet. Cut out the carpet as well as padding with the help of a utility knife to fit the block of wood that is, to a small degree, larger than the bracket.
- The wood should be placed or fixed centered in opposition to the door frame on each side. Fasten the wood into the subfloor using screws before installing the bottom pivot bracket on top of it.
Installing The Doors
- The guide pins should be placed, fit, or pushed into the holes at the top of the doors. They will need to be lightly or softly tapped into the holes in order to get them all the way in. It is important not to damage the pins. Then, the adjustable pivots can be pushed and tapped into the holes at the underside of the doors.
- The doors can then be bend in half and lifted into place by inserting the top pin into the top bracket and then the underside pivots into their brackets. The underside pivot can be moved as long as it is 1/4 inch away from the frame in order to give the door room to open and close.
- It can also be altered or moved for height to get the correct alignment of the doors. On the back of the doors, alignment brackets are placed or fixed 18 inches from the floor.
- They interlock each other before keeping the doors aligned when they are closed. Lastly, the doorknobs can be placed or fixed. The screws are inserted from the back and the doorknobs are just fasten onto them in the front using screws.