Install Undermount Sink Without Clips: 5 Easy Steps Of Installing Undermount Sink


5 Easy Steps Of Installing Undermount Sink Without Clips Or Brackets

If you want to install undermount sink without using clips or brackets in the kitchen area at your home, then you simply need to go through all the steps mentioned below carefully:

Step 1: Preparation

A compelling step when installing your kitchen sink with the adhesive is to clean both your countertop surface and your sink surfaces that contact each other during the installation process. Wiping your surfaces with your clean rag and acetone removes any grime, dirt, grease, and that could hinder the process. You should follow all instructions and provisions listed on the acetone bottle when using this product. After cleaning, allow the sink surfaces to dry comprehensively usually just for a few minutes.

Step 2: Adhesive

Although several adhesives easily available on the market are also suitable for kitchen sink installation, the industry standard is clear or crystalline silicon. The material bonds are better than any other types of adhesives and also used to seal around your under mount sink after installation. A compassionate bead or chord of silicone is applied around the contact surface of your sink. The contact surface is the area of your sink that will contact your countertop. The contact surface for an under-mount sink is the generally 1-inch lip on the same side as your sink openings. Drop-in sinks require applying the silicone to your underside of the sink's perimeter opposite your sink openings.

Step 3: Installation

The under-mount sinks install to the bottom of your countertop. Installers place your sink in your cabinet underneath the sink opening before applying your adhesive. After applying the silicone adhesive, the installer lifts your sink until it makes contact with the underside of your countertop. Depending on your number of drain openings, 1-2 bar clamps, and a cross brace hold your sink into place. One end of the bar clamp grabs the bottom of your sink through with your sink drain opening while the other end attaches to the cross brace. The installer adjusts your sink’s position and tightens the bar clamps until your sink is snug with your countertop. The clamps remain in place until your silicone cures. Drop-in your sinks install accessible than their under-mount counterparts do. Adhesive applies under the lip of your sink, which is dropped into place & adjusted to its actual location.

Step 4: Cleaning

Both drop-in and undermount sinks require cleaning instantly after installation to remove extra silicone around your sink edges. Extra silicon seeps out from under your sink edge after tightening your clamps. Before removing the extra silicone or tool, smooth it into the joint with your finger. Apply supplementary silicone that is needed to form an uninterrupted seal around your sink. Remove any silicone residue with a rag & acetone before it dries.

Step 5: Epoxy

Your final step to installing an undermount sink without hardware is to add increased support for sinks that incorporate garbage disposal. When filled with clean water, your garbage disposal side of your sink can weigh up to 100 pounds. In order to reduce the chance of your sink disentangle from your countertop, you need to add additional support. The professional installers use two-part epoxy to attach small blocks of granite or acrylic material to the bottom of your countertop overlapping your sink lip. Since your epoxy is very fast setting material, it also allows the installer to connect the plumbing instantly after your sink installation, which would otherwise not be possible until your silicone dried. Since a drop-in sink is supported by your countertop, it is not necessary to use your epoxy & blocks.
Connect with GetRit GetRit.com Furniture Facebook GetRit.com Furniture Twitter
Copyrights (©) 2024 GetRit.Com   All Rights Reserved