Step By Step Process Of Repairing Chair Legs Using Wood Filler
Some of the common issues when it comes to wooden chair legs include hairline cracks, chips or gouges. These issues in chair legs may occur due to the reason that feet scuff the bottoms or the chairs knock in opposition to the walls, floors as well as table legs. You can repair this damage by applying wood filler, which is a product that can be very helpful in filling hairline cracks, gouges and small chips, which in turn makes your chair look new again. Wood fillers are available in a huge range of shades that can blend or mix almost perfectly with your wood chair legs, and the majority of the shades are stainable, which can help you achieve a closer match. If you are looking to use a wood filler in order to repair chair legs, then you need to go through the below-mentioned step by step process carefully & achieve the desired result of your work:
- Clean & Sand The Area: First of all, clean the damaged area using soapy water in order to get rid of dirt as well as grease and allow the wood to dry. Sand the area using fine-grit sandpaper if, in case, there are loose wood fibers or crumbly sections. Work in the direction of the grain if you are looking to create a smooth work surface to apply the filler.
- Apply Stainable Wood Filler: Now, apply stainable wood filler, in order to cover cracks as well as gouges, with the help of a narrow plastic putty knife. Work the filler into the gouge, chip or crack using the putty knife as long as it is level with the adjoining wood or slightly higher. When it comes to deep holes or cracks, spread the wood filler in 1/8-inch layers. Give each layer some time to completely dry before you apply the next.
- Smooth The Filler Using Putty Knife: Next, smooth the filler with the help of a putty knife before scraping away any excess in order to make sure that the repair amalgamates with the rest of the chair leg. Wood filler is workable for nearly 10 minutes, so you need to work quickly to prevent drying.
- Allow The Filler To Dry: Allow the filler to dry for approximately 20 to 30 minutes, before sanding the repair smooth using fine-grit sandpaper. Leave the filler to dry overnight & then apply any stain or other finish products.
- Apply Stain To The Repaired Wood: Finally, apply stain to the repaired wood with the help of a paintbrush in order to blend the filler color with the rest of the chair leg.