Step By Step Process To Remove Gel Stains From Fiberglass Door
Gel stain is a kind of stain that is thicker in nature & is usually used to stain vertical surfaces, which may include doors and walls. This is, due to the reason that the stain will not drip as well as run like liquid stains. When staining fiberglass using gel stain, the stain will not immerse or sink into the fiberglass like stain does with wood. Because of this, it is extremely easy & simple to get rid of the stains from fiberglass doors. Always use gloves as well as goggles when using chemical strippers in order to safeguard your skin and eyes. If you are looking to remove gel stains from a fiberglass door, then go through the below-mentioned simple step by step process carefully & achieve the desired result of your work:
Thing's You Will Need
- Phillips-Head Screwdriver
- Goggles
- Gloves
- Drop Cloth
- Paintbrush
- Fiberglass Stripper
- Cloths
Step By Step Process
- Remove The Door From Its Hinges
First of all, pull out the door from its hinges by unscrewing the vertical screw that takes hold of the door on the doorjamb. Take out the hinges by unscrewing them from the fiberglass doors & then setting them aside. - Place The Door On A Worktable
Now, position the door on a worktable above a drop cloth. Soak a paintbrush into the fiberglass stripper. - Paint The Stripper Onto The Fiberglass Door
Next, paint the stripper onto the fiberglass door but make sure to paint in small sections. Leave the stripper on in accordance with the manufacturer's instructions, usually for two to three minutes. This, in turn, will help make sure that the stripper gets rid of only the stain and not the fiberglass door's protective coating. - Wipe Off The Stripper Sealer
Now, wipe off the stripper sealer with the help of a clean cloth. Use several clothes in order to make sure that you are rubbing off the stripper. Repeat the same process with the rest of the door. - Remove The Stripper Residue
Finally, soak a clean cloth in clear water before rubbing it over the entire front and back of the fiberglass door in order to get rid of the stripper residue. Reattach the hardware as well as put the door back on its hinges.