How To Stain Concrete Countertops To Look Like Marble: Easy Steps For Staining

Easy Steps For Staining Concrete Countertops To Look Like Marble

Choose Colors: In the first step the user needs to choose the color that will best suit the decor. the user can go for something that's high-contrast or something which blends nicely with the surrounding decor. The user should look for the coloring and texture to their taste, and keep a close look at it as the user is trying to duplicate it on the countertops.
Cleaning: The next step is to go for the cleaning process clean the concrete countertops thoroughly with the solution of mild soap and water. The user should allow concrete countertops to fully dry before heading on to the next step.
Sanding: After cleaning is done then sand the areas with holes and dents, and then fill them with concrete patch. For the excess putty Level it off the with a putty knife. It is advisable to allow the concrete patch to dry to fully dry out and then sand it again so that it will be smooth. Take a clean dry cloth then Wipe off the counters again. At last, the user needs patched-up areas with sealer.
Painter's Tape: The area that the user don't wish to paint Cover with painter's tape.
Apply A Primer: In this step the user needs to apply the primer but which is designed for concrete. Mix the base coat color with the primer for better color coverage mix one-part base coat, three parts primer then allow it to dry and it's important to apply a full coat of base color. Allow to dry completely.
Acrylic Glaze: With the topcoat color mix the acrylic glaze the mixture should be four parts glaze with one part paint in large enough bucket. Now the user needs to put a two-foot by two-foot section of plastic drop cloth into the glaze mixture, after remove the cloth drop off excess drips. It is advisable to wear a rubber close while doing this job.
Lay The Drop Cloth: Apply the plastic over the base coat, and at the same time scrunching it up in places. The scrunching will make cracks and veins. The user needs to Repeat this process but every time use a fresh drop cloth until all the surface is covered with this texture. Before applying the veining its important to allow the paint to dry completely.
Color Of Veins: For the veining process the user needs to dip a dagger or turkey feather brush in the veining color. The marble veins can be darker or lighter than the base coat this depends on the user choice. Although the user can Check the patterns on the image of marble that the user has selected. Lightly touch the tip of the brush onto the glazed surface, and carefully try to duplicate the direction as well directions of veins selected marble. In case the user is feeling uncertain then practice on a piece of paper before starting the process .
Sealer: At last, the user needs to apply a sealer designed for painted concrete surfaces but After the veining is dry.