Easy Steps Of Sealing The Edge Of A Cut Carpet
Carpet remnants are usually pieces of the end of a large roll of carpet. Since the customer is not going to look for a small piece of carpet in a specific style and color, the carpet manufacturer usually sells these short pieces at a huge discount. Due to the reason that they are generally small or odd sizes, they may not be appropriate for use as wall-to-wall rugs, however, some carpet remnants make excellent rugs for a distinctive room where you are unable to install conventional rugs.
- Cut The Edges Of The Carpet Remnant: First of all, cut the edges of the rug residue with the help of a utility knife so that each edge is clean and the overall residue is the desired size. If you are looking for a conventional rectangular or square rug, then use a right-angle tool so that your corners make proper 90-degree angles. Draw lines, if needed, using a pen on the back of the carpet and with the help of a yardstick guide your cuts. Put a board or cardboard underneath the carpet in order to prevent having a detrimental effect on the surface beneath as you cut.
- Run A Bead Of Glue Through Each Edge: Now, sprint a bead of glue smoothly through each edge of the carpet. Plain white or craft glue can be used for this purpose, however, carpet seam sealer is a type of glue that is specially designed to prevent the carpet from falling apart. Make sure to get the glue only on the carpet backing, and not on the fibers. With the help of the tip of the bottle or your fingers, you can easily get the glue well into the backing.
- Peel Adhesive Covering: Next, remove some of the adhesive covering from your binding, which can help you expose a sticky edge. Press the back of the carpet in opposition to the binding, with the edge of the binding flush through the edge of the carpet. Start from the center of one side of the remnant & keep removing and pressing on every side of the edge of the carpet. At corners, trim along the part of the binding with adhesive on it to the edge. Overlap the edges of the adhesive part in order to make the binding properly wrap around the corners.
- Trim Off The Excess Binding: After that, cut the leftover binding as soon as you have reached the starting of the binding wrap. Seal the two edges together with the help of hot glue. You will need a thin nozzle tip for the glue gun in order to increase your amount of control as well as create a small bead.
- Run A Line Of Hot Glue: Sprint a line of hot glue, still with the help of the nozzle, around the carpet betwixt the carpet edge and the inner edge of the binding. Press the two together in order to get a better seal while the glue is still melted. This will help the binding stick better as well as help avoid coming apart. Hot glue is extremely hard to remove, so be careful while dealing with hot glue.