Easy Process For Sanding Louvered Doors
If you want privacy in your room but at the same time there should be natural ventilation and quietness for rest, then you can use Louvered doors for this purpose. Louvered doors allow free passage of air even if the door is closed. These types of doors have rows of horizontal strips that permit air circulation. Some of the louvers are movable, however, metal doors usually have fixed or immovable louvers. Any defect in the paint, like all over the screw holes or where paint is scratched, lets moisture wear away the underlying metal. Remove the door from its hinges or tracks and then take off all the hardware before repairing the finish with new paint. In order to sand the louvered doors, follow the below-given steps carefully:
- First of all, it is necessary to remove any hardware attached to the louvered doors, including handles and locks, due to the reason that these might get scratched during the sanding process.
- Now, it is time to sand each slat in a horizontal motion and make sure to get into the cracks or splits on every side. Start the sanding process from the top and move smoothly down in order to be certain that all louvers are addressed. If in case a specific spot can not be accessed easily, then there are numerous paint stripping tools particularly designed to reach tight angles. Finally, run your hand over each louver in order to ascertain or establish if any wood burrs are present.
- After that, start sanding the larger flat panels of the door. The use of a motorized circular sander should be avoided, due to the reason that this could unintentionally damage the grain. Pay special attention to the joints betwixt each panel in order to ensure a smooth finish.
- The next step is to sand the exterior edges of the door. After each & every surface has been addressed, then with the help of a damp rag or a small vacuum, suck up any sawdust that remains. You need to repeat the process more than once if you are sanding for the purpose of removing paint or stain.
- Intensely difficult to move, remove, or cure areas might also benefit from the use of a paint stripper or a varnish remover. Always make sure not to harm the underlying wood and it is better to go through the instructions before starting the sanding process.