Step By Step Instructions Of Sanding Cedar Siding
Cedar siding is regarded as one of the long-lasting & attractive building materials that have been used widely throughout the United States. Cedarwood is extremely easy to work with due to the reason that it is lightweight as well as stable. In order to get rid of surface defects and make the wood ready for painting or staining, it is important to sand the cedarwood. Rougher sandpaper can be used when it comes to getting rid of the material and finer sandpaper for smoothing the wood surface as well as preparing for finishing. Sanded cedar wood should be treated using a wood brightener in order to condition the wood for finishing. In order to sand the cedar siding, go through the below-mentioned steps carefully & achieve the desired result of your work:
- Clean The Cedar Wood: First of all, you need to clean the cedar wood with the help of a wood cleaner. The wood cleaner is usually sold in concentrated form. Go through or read the manufacturer's instructions regarding the proper dilution when it comes to cleaning cedarwood. Combine or put together the cleaner before applying it to wet cedar siding.
- Scrub The Wood Forcefully: Now, scrub the wood forcefully with the help of a nylon scrub brush. After that, rinse the siding, in a thorough manner, with water. Give the wood at least 24 hours to dry fully before you start sanding the wood.
- Apply Rough Sandpaper: Next, you need to select rough sandpaper in order to get rid of the damaged wood fiber. Using a belt or disc sander built-in with 80-grit sandpaper will generally take off high quantities of surface material.
- Sand In The Direction Of The Wood Grain: Begin in one corner and start sanding in the direction of the wood grain. Move comparatively quickly in order to prevent getting rid of too much wood fiber. The 80-grit sandpaper will leave the sanded surface somewhat and extremely rough and scored with fine grooves.
- Rinse Sawdust From The Siding: Fit your sander having 120-grit sandpaper for finishing. Go back over the cedar wood using the sander in order to smoothen the surface. After you finish the sanding process, rinse all the originated sawdust from the siding with the help of a hose.
- Apply A Wood Brightener To Wet Wood: Combine or put together and spread a wood brightener to wet wood. Let the wood brightener remain on the cedar siding for nearly 30 to 45 minutes. Then, rinse the siding, in a thorough manner, with water. Make sure not to scrub the siding when you are performing the wood brightening process.
- Allow The Wood To Dry: Finally, allow the wood to dry for approximately 24 hours before applying paint or stain.
A wood cleaner, as well as a wood brightener, contain chemicals that can be very dangerous to the skin and eyes. Therefore, it is important to use proper protection, which may include using rubber gloves and eyewear, when you work with these products. Sanding cedar wood can produce or create dust that is dangerous if inhaled. Wear a NIOSH-approved ventilating mask when you sand cedar wood. Keep all these points in mind when you are sanding a cedar siding, as safety comes above all.