8 Easy Steps To Reupholster A Square Bar Stool Seat
The users can easily reupholster the square bar stool seat by following the below-mentioned steps:
- Gather All The Tools And Materials: The users need to start by gathering all the materials and the tools that they require while accomplishing this task like Screwdriver, 3/8-inch staples, Straight pins, Staple gun, Scissors, Craft glue, and foam padding as well.
- Turn The Bar Stool: The users then need to turn their bar stool towards its upside-down direction and then detach all the hardware that is beholding the seat with the frame by using the screwdriver and then place the seat aside so as to use it again in the future. The users also need to save all the screws and the nuts in the small cup in order to use them again accordingly.
- Remove The Old Cover: The users then need to detach the pre-existing cover of the seat so as to use it as the seat pattern. Then they require using the screwdriver to detach all the staples that are holding the seat cover respectively.
- Trim The New Fabric: Then they need to lay the pre-existing seat cover over the top surface of the new fabric and then they need to pin both the fabric and trim the new fabric accordingly.
- Affix The New Padding: If in case the users find out that pre-existing padding of the stool is damaged then they need to buy the new padding as of the same width. Then they need to affix the new padding to the stool by using the craft glue and then let the craft glue to get dried off completely before placing the new seat fabric.
- Lay The Seat Fabric: Then the users need to lay the new trimmed seat fabric over any hard surface towards its wrong side upwards and then lay the bar stool seat over the new fabric.
- Grasp The Fabric With The Seat: Then they need to grab one edge of the front-most fabric and then wrench it diagonally beside the seat and then use the staple gun and then staple down the fabric accordingly. The users need to repeat the same process while stapling down the second edge of the fabric. The users need to repeat the same while affixing the fabric edges at the backside of the seat and they need to keep the seat fabric at the close-fitting possible.
- Re-Attach The Seat: At last, the users need to affix the seatback to the bar stool by using the pre-existing hardware as well as the screws.