How To Replace The Runners In An Old Dresser: Easy Procedure Of Replacing The Runners In An Old Dresser


Easy Procedure Of Replacing The Runners In An Old Dresser

Older dressers often had wooden runners, which deteriorate with time and use, but that doesn't mean you should stop using it because it's likely made better than a new one. The construction, maintenance, and installation of this kind of runner are simple. It's a reasonably straightforward process to update it to a metal runner. Before 1960, most older pieces of furniture were constructed entirely of wood. Even the now ball-bearing drawer runners were constructed from a single piece of lumber. On the runner, a dado was carved in the center, and a corresponding tenon was either built into or attached to the drawer. To give the drawer movement, the tenon slid up and down inside the dado. These function well for a long time before eventually failing. They become sloppy, crack, split, or warp, causing the dresser's drawers to bind or come free. They are simple to swap out.

Step 1: Take All Of The Drawers Out From The Dresser

The dresser's drawers should all be taken out. If the dresser has a back, take off the back by removing the screws holding it with a screwdriver. Trace around each runner's attachment points to the dresser using a black marker.

Step 2: Loosen The Runners & Remove Them

Reach into the dresser from the rear. To force the runners to loosen, firmly bump them sideways, up, or down with your palm. One by one, grab and twist the runners until they are totally off, then take them off. Remove any bent screws or nails that are still inside the dresser using a pair of diagonal pliers.

Step 3: Measure The Width Of The Runner

A tape measure can be used to determine the runner's width. Cut the poplar pieces to the runner's width using a table saw. The dado in the runner should be measured for both width and depth. To reproduce the dado, install a dado blade on the table saw and cut the poplar pieces. The old runners' length should be measured. Using a miter saw, cut each runner to the proper length.

Step 4: Check The Old Runners

Examine the previous runners. Drill holes where nails would have been used to attach the runners to the dresser frame using a cordless drill and a 3/16-inch drill bit.

Step 5: Place The Runners Into The Dresser From The Back

Using the black marker outlines from Step 1, insert the runners into the dresser from the rear. Use a hammer to tap them into position. After placing screws in the holes, tighten them down firmly with the cordless drill. Fix the dresser's back with screws. Reinstall the drawers.
Connect with GetRit GetRit.com Furniture Facebook GetRit.com Furniture Twitter
Copyrights (©) 2024 GetRit.Com   All Rights Reserved