General Overview
Maytag washer or dryer is considered as one of the best when it comes to washing your clothes, as they are long-lasting & strong, which are very helpful in washing the clothes rigorously. The life span of Maytag dryers is nearly 8 to 12 years, however, if you clean the lint trap of the dryer at a regular interval, then its life span can be extended. To keep this type of dryer up to date, you need to clean its hoses, heating element, as well as dryer ducts at least on a yearly basis. The heating element in your Maytag dryer is composed of a metal chamber and coils. As soon as you switch your appliance on, the electricity moving to the dryer heats up the coils, which in turn, also heats up the air running through the component’s metal chamber and sent into the appliance’s drum. If in case the heating element is defective, the coils won’t get hot, which means the air circulating through the drum will not be able to dry your clothes. When a heating element is faulty, you can frequently find out the problem by carrying out a visual inspection. If the coils are burnt out, then it is necessary to replace the component.
Step By Step Process Of Replacing A Maytag Dryer Heating Element
Once you open the door of your Maytag dryer, after the completion of a dry cycle and if you still find your clothes as wet as they were at the start of the dry cycle, then it specifies that your appliance is no longer producing heat. In order to assist you to identify the fault behind your non-heating dryer, go through the step by step mentioned-below. Before starting the repairing or replacing process, make sure to disconnect it from the wall or switch it off at the circuit breaker. Also, protect your eyes as well as hands by wearing safety equipment during a repair process.
- Take out your dryer forward, and slide to the back of the appliance. Detach the screws grasping the large, rear panel onto the dryer frame and upraise the panel up and off your appliance.
- Before you take out the heating element from your dryer, disengage the wires from the high limit thermostat, which is situated on the side of the heating element. As soon as the wires are disengaged, eliminate the thermostat from the heating element. Then, disengage the wire moving to the heating element.
- Remove the screws attaching the heating element to the appliance, and take the faulty component out of the dryer.
- Hold the new heating element, and secure it to the dryer with the help of mounting screws. Put back the high limit thermostat, and restore the thermostat and heating element wires.
- Fix the rear panel again and connect your appliance back into the outlet. Start a dry cycle in order to make sure that the new heating element sorts out your appliance’s malfunction.