Step By Step Process Of Replacing Fascia Board Yourself
Fascia board is a kind of board that is used to take hold of your gutters in place and helps in protecting the edges of your roof. These sections are exposed to a lot of moisture and with the passage of time can start to rot. The fascia is regarded as one of the long wooden boards that runs parallel to the plane of the horizon on the edge of the roof. Generally, the size of the fascia board is either 2×8 or 2×6. This board helps in connecting the gutters to the roof truss. If there is no wood in this spot, that’s likely due to the reason that your fascia boards are protected with a vinyl or aluminum cap in order to match your gutter system. Homes with no fascia boards at all are very rare. The state of being without or not having enough of a fascia board is generally against building codes and should be corrected in order to safeguard your home.
Tools & Materials Needed
- Circular Saw, Ear Muffs & Safety Goggles
- Ladder, Leather Gloves & Measuring Tape
- Multi-Grip Pliers, Nail Gun & Pencil
- Saw Horses & Wrecking Bar
- Fascia & Galvanized Nails
- Gap Filler & Short Block Of Timber
Step 1: Measure The Existing Fascia Board And Prepare Tools
One of the easiest & simplest ways when it comes to fixing rotten fascia board is to cut out the old section before replacing it with a new piece. For that, first of all, get all the tools & materials needed for the process ready. It is important to take the measurement of your fascia board first in order to make sure that you get a replacement piece of timber to match.
Step 2: Remove The Guttering From The Fascia Board
Guttering is usually held onto the fascia by metal clips. With the help of a pair of multi-grips, pull these clips back in order to release the section of guttering. As soon as the whole section is free, roll it out before placing it on the ground. Some of the sections of guttering can be quite long, therefore, it is a good idea to take the assistance from someone in your family or friends.
Step 3: Lift The Roof Off The Top Of The Fascia Board
With the help of your wrecking bar, pry the nails out of the roofing over the rotten piece of fascia. Then, raise or elevate the roofing off the board before placing a timber block underneath to prop it up. Make sure you get rid of any gutter brackets that might be in the way.
Step 4: Mark The Line Where You Will Cut The Fascia Board
Start from the rotten section, locate the nearest point where your fascia has been fastened using nails into the roof joist. Draw a line betwixt the nails and the piece you are planning to get rid of, this, in turn, will make sure that the retained fascia is still properly fastened using nails into the roof.
Step 5: Cut The Fascia Board
Before starting to cut out your fascia, adjust your saw blade to the depth of the board. This will help you cut safely through the board without bluffing your blade on the wall behind the fascia. Start cutting the fascia board from the bottom of the board.
Step 6: Remove The Old Fascia Board And Replace It
With the help of your wrecking bar, pry the rotten fascia off the building. As soon as you have removed the rotten board, calculate & evaluate your space for the replacement fascia board. Cut the fascia to length and fasten it into place with the help of galvanized nails.
Step 7: Paint The New Fascia And Put The Guttering Back Into Place
Finally, after replacing the old fascia board with the new one, it is time to prepare the surface for painting. With the help of your gap filler, tidy up the join betwixt the old and new fascia. Then, lightly sand the whole fascia. Next, reattach the metal gutter clips, before putting the guttering back on and it is ready for painting.