As soon as you feel that your exceptional area rug is slipping, don't throw it out, instead, you can repair a rubberized non-slip backing with a liquid product that dries to take hold of the floor or offers skid-resistant properties to your rugs. Some of the paint-on products are composed of natural latex, ammonia, and water. The majority of the non-skid backings are washable that can easily be moved from side to side or back and forth in a machine and line-dried. Go through the product contents and recommended maintenance before ascertaining or establishing which type best suits your needs.
Step By Step Process Of Repairing A Non-slip Rug Backing
Rubber backing is regarded as one of the best options when it comes to keeping scatter rugs in place, however, rubber breaks down with the passage of time. It is vulnerable and prone to damage from chemicals as well as the heat present in the wash and dry cycles of modern appliances, the continuous wrinkling and smoothing from foot traffic, and even vulnerability to ultraviolet light indoors as well as outdoors. The tops of rugs typically last much longer in comparison to the backing, though, so if you don't want to throw out the rug, simply fixing the backing will give the rug many more years of use.
- Wash & Rinse: First of all, wash as well as rinse the rug using as insufficient amount of detergent as possible in order to get it clean. Make sure not to use fabric softener or other additives in each of the wash or rinse cycles. Hang the rug in order to make it completely dry.
- Lay The Rug: Now, position the rug upside down on a stable, even & uniform surface where it can remain for nearly 24 hours undisturbed. Your room should be warm, at least 65 degrees F when it comes to curing the latex rubber properly.
- Remove Scraps Of Old Backing: Next, get rid of any scraps of old backing, string, etc., from the rug in order to make sure that the surface is as smooth & uniform as possible. Open a liquid latex rubber can before stirring rigorously in order to mix contents that may have settled.
- Apply Liquid Latex Coat: After that, soak a brush into the liquid latex, and spread a generous coat to damaged and shabby areas of the backing in order to amalgamate any flakes as well as cracked areas. If in case the entire area of backing is loose but still attached, then apply a thin coat of latex, which acts as a glue, to the area beneath the damaged portion and press the old backing down over it. Allow the latex to cure for several hours as long as it is solid and not sticky.
- Extra Liquid Latex Coat: Put or spread an extra liquid latex coat over the entire back of the rug in order to make a single, uniform surface over repaired areas. Give the liquid latex at least 24 hours to cure properly before using the rug again.