How To Repair Cracked Fascia Board: Easy Process To Repair & Replace The Cracked Fascia Board


Easy Process To Repair & Replace The Cracked Fascia Board

Fascia boards are vulnerable & prone to water damage, which as a result leads the wood boards to rot that can become loose and are unpleasant to look at. If you are looking for fine home makeover, then you need to repair or fix your fascia boards. Fascia boards run parallel to the plane of the horizon underneath a roofs edge and can be composed of wood or sheet metal. These boards are placed or fixed in segments and the seams should be arranged at the rafters which helps safeguard the ends from water damage. If in case the paint is peeling from the fascia board, but the wood is in good condition, then it is important to sand as well as repaint your boards. If you notice indications of rot, then you will need to cut those sections out at the rafters before replacing them.

Step One: Inspect The Existing Fascia

First of all, you need to inspect the fascia board in order to find out the extent of the damage & how much of the board you need to replace. It is also important to take the measurement of the old board, so that you can select the correct replacement board. If you are looking to replace your fascia board as part of a full roof replacement, then you will need to install the new shingles before addressing the fascia.

Step Two: Remove Gutters And Drip Edge

You definitely can not replace the fascia board without getting rid of the gutters, due to the reason that the gutters are mounted to the board. Therefore, it is important to carefully get rid of the gutters from the board. Generally, the identical gutters can be reinstated or restored on the new fascia board, provided they are in good condition. Also, you may need to get rid of the drip edge, which you can also reuse if it is in good condition, except if that violates the terms of your manufacturer’s limited warranty.

Step Three: Remove Existing Fascia Board

With the help of the claw of a hammer, a pry bar or another tool, you need to carefully get rid of the nails from the fascia board and take it down.

Step Four: Measure And Cut

Next, it is time to calculate or evaluate and cut the new fascia board to fit. You may need to cut the fascia into more manageable sections. If so, the section must stretch or spread at least two rafters in order to make sure that both ends can be nailed into place. To make nailing easier, you may need to mark where the rafters are on the board before you place it so that you drive the nails into the rafters. You will also need to bring together or into contact the corners of the fascia board, which you can do by cutting the board on 45-degree angles to form a joint.

Step Five: Cover The Seams

The seams betwixt each piece of wood needs to be sealed against water. You can seal the seams of the wood with the help of a silicone caulking or another type of sealant.

Step Six: Seal The Wood

Now, you may need to seal the wood itself, for which any exterior wood sealant will work exceptionally well, and you may need to follow it up with a coat of paint in order to match or complement your gutters. There is no reason when it comes to painting the wood if you use fascia trim. The trim will shield the wood, therefore, it won’t be visible. Instead of painting, you can install the trim by measuring as well as cutting the trim to fit and then fastening it to the fascia board using nails. Some of the very high-quality pieces of wood, including cedar, may be left without sealant, in certain circumstances.

Step Seven: Install Drip Edges And Gutters

Finally, after the fascia is in its exact place, you can easily reattach your drip edge as well as gutters.
Connect with GetRit GetRit.com Furniture Facebook GetRit.com Furniture Twitter
Copyrights (©) 2024 GetRit.Com   All Rights Reserved