How To Repair Click Lock Vinyl Plank Flooring: Step By Step Guide Of Repairing Click Lock Vinyl Plank Floor

Step By Step Guide Of Repairing Click Lock Vinyl Plank Flooring

A sort of floating floor known as a "click lock floor" is composed of planks that link together towards the sides and lock. The click lock flooring doesn't require the use of glue or nails. When two planks are inclined and placed next to one another, they interlock. A 14-inch gap is necessary for click-lock flooring around the room's perimeter. Expanding and contracting can harm the floor boards if the spacing is not supplied. The best approach to repair a damaged plank without using nails or glue is to unclick it, remove it, and then replace it with a new board. In order to accomplish this repairing process, you only need a pry bar and a circular saw.

Step 1: Find The Damaged Area Of The Boards

First and foremost, find the damaged area of the boards. Find the wall next that is pointing in the same direction as the boards. Now you must take the boards out of the wall and replace them with new ones in the damaged areas.

Step 2: Pull The Baseboard Off With A Pry Bar

From the wall closest to the problem area, remove the baseboard. Pull the baseboard off with a pry bar, then put it aside. The flooring edge where you will begin removing the boards is hidden by the baseboard. When you're finished, you'll put the baseboard back in place.

Step 3: Examine The Area Where The Planks Meet The Wall

The spot where the boards meet the wall needs to be examined next. Attempt to grasp the edge of the planks with your fingers; if there isn't enough room, try inserting the edge of the pry bar into the opening.

Step 4: Lift The Plank That Is Closest To The Wall

The board should slope down to the floor at an angle by raising the edge closest to the wall. By doing this, the floor lock will be released. To remove the board, simply slide it backward. Unlock the boards one at a time until you reach the damaged board or boards. Discard the damaged boards by removing them.

Step 5: Replace All The Boards That Are Damaged With New Ones

In addition to the remaining boards leading back to the wall, replace the damaged boards. To the next row of boards that are still in place on the floor, place the edge of a new board. The end you are holding should be 5 to 6 inches from the ground while you are holding the board at an angle so the edges of the two boards meet. Firmly press the two boards together before lowering the end you're holding to secure them together. Continue until you come to a wall.

Step 6: Leave A 1/4 Inch Gap Between The Last Board And The Wall

Before you're done, be sure to leave a 14-inch space between the last plank and the wall. Use a circular saw to cut the plank to the necessary width and then install it if the final board is too large and not allowing a gap. You can now replace the baseboard you took out in step 1 to fill the hole.