Easy Process Of Removing Paneling Glue From Drywall
The majority of the people make the mistake of choosing glue rather than nails in order to hang wood paneling. If you have to remove the paneling in the future for some reason, then at that time, you may realize that using glue was the biggest mistake that you have made when hanging wood paneling. This is due to the reason that the paneling is more difficult to remove, and also the glue residue will remain on the wall, and the paneling won't come off easily without at least some damage to the wall material. One of the best ways to reduce or lessen this residue in order to get rid of the paneling expeditiously is to use heat. After pulling off the paneling, you should be able to get rid of the residue while it is soft.
Things You Will Need
- 4-Inch Paint Scraper
- Electric Heat Gun
- Heat-Resistant Gloves
Step 1: Work A Paint Scraper Under The Panel's Seam
First of all, track down a seam betwixt two panels and work a 4-inch paint scraper underneath the bottom corner of one of them. Push the scraper in as long as it will go without making a hole or dent into the wall.
Step 2: Heat The Paneling With An Electric Heat Gun
Put an electric heat gun to its lowest setting and make sure to wear heat-resistant gloves. Point the gun towards the area where you put in the scraper and take hold of it about 6 inches away. Move it around the area in order to heat the paneling, however, don't allow it to linger in one place for too long, 30 seconds is enough, otherwise, you may burn the paneling.
Note: An infrared paint stripper is safer to use as compared to a heat gun if you have one. When you take hold of the rectangular stripper on the surface of the paneling, it will help you soften the glue without overheating the paneling or the wall framing.
Warning: Prevent the use of a torch or open flame when it comes to heating the glue. Similarly, keep away from overheating the glue by taking hold of the gun in one area for a longer period of time without moving it. The glue can catch fire, therefore, it is also best to double-check that everything has fully cooled before leaving the job site.
Step 3: Begin Prying Up The Panel As The Glue Softens
Pry upward with the help of a paint scraper as soon as the glue softens and the paneling becomes loose. As soon as you can, grip the corner of the panel with the help of your hand and pull it up as you slowly move the gun toward the opposite corner.
Step 4: Remove The Panel From The Wall
After softening all the glue behind the paneling by heating it, pull the panel off the wall. If you pull it off early & untimely, you may pull off the wall surface underneath.
Step 5: Scrape Away Any Remaining Glue
Re-soften the glue residue that persists on the wall using the heat gun after you have fully removed the paneling. While the residue is soft, get rid of as much as you possibly can with the help of a paint scraper.
Note: Whatever residue you are not able to get rid of with heat may come off using a solvent, including mineral spirits. If the residue is on drywall, it is also possible to build up the surface of the wall using joint compound to mask it.