Two General Methods Of Removing Full Extension Drawer Slides
You may occasionally need to manually remove the drawers from a cabinet, dresser, or comparable piece of furniture to complete cleaning and moving activities. Most of the time, removing drawers is simple, but depending on the sort of drawer you're dealing with, the procedure may change slightly. The majority of wood-glide and free-rolling drawers will release smoothly with a little push or a slight tilt. You must first remove the screws keeping the drawer in place if the drawer has a stopping device, such as stabilizer screws or anti-tip wires.
Method 1: For Free-rolling Drawers
- Pulling The Drawer As Far Out As It Goes
Standing directly in front of the drawer is the initial action. After that, you must grasp a knob or handle that is on the front panel. Pull it up and start sliding it. Continue until the drawer shuts off by itself. If no stopper is utilized, it ought to come out immediately away. However, if there is resistance, move it slightly in another direction. After that, this ought should liberate it. Don't forget:- For free-rolling drawer types, there should be a little raised mechanism on the front that serves as a stopper. The purpose of these is to stop the drawer from coming out.
- Before stretching the drawer out, make sure there is enough distance between you and it.
- Even in the absence of a stopper, wood glide may contain sticking places. Therefore, keep an eye out for the obstruction and give the drawer a firm tug. This will assist it in getting through that barrier.
- Tilting Drawer Downwards
You want to slightly elevate the drawers' back ends. Simply push the drawer from both sides to accomplish this. This will make it possible to lift the lips or wheels on the back edge a little amount. Additionally, this needs to rise above the front track's stopper. This will eventually enable the remainder of the inserted drawer to be pulled out with ease. You'll need to move around and jostle a bit in this area as well. in order for the wheels to untrack. Just try not to be too harsh. Otherwise, the hardware that is attached could be harmed. - Let It Come Out
The rest of the process is rather straightforward once the wheel or back edge reaches the stopper. The drawer only has to be gently slid off its track. And gradually, it will emerge from the opening in the furniture. Place it on a solid, level surface to rest. You can do the exact same procedure with the remaining drawers in the meantime.
Method 2: For Drawers With Levers
- Check For The Track Levers
You must first inspect the exterior walls to find the track levers. On each side of the drawer, there ought to be a lever. This is exactly in the middle of the track. It could be uniformly straight or slightly bent. As long as they are in place, these serve a part in preventing the drawer from being pulled out. You should avoid getting your fingers stuck in overlapping tracks when opening a door. So take care. You can typically find full-extension slide tracks in 12-inch drawers. Typically, these have straight tabs. - Same Pressure On Both Levers
You will now press down on both levers simultaneously with your thumb or forefinger. Make use of your remaining fingers to support the drawer. You will use your thumb or fingers to disengage levers in the interim. The easiest approach to guarantee that drawers won't abruptly tumble down or come off tracks is to do this. If a drawer is configured differently than others, you might need to pull up rather than push down. However, this case is not very common. - Let The Drawer Come Out
Try to pull the drawer out straight while holding the levers down with your hands. It should continue to slide closer to you over time. Additionally, while doing so, you will maintain both levers continuously disengaged. Lift it out straight as it reaches the end of the track. You can set it aside and use the same procedure on the other drawers. You could discover that the metal retainer tracks are still extending in some furniture. even when the drawer is entirely empty. For your own safety, you should make sure that the tracks are moved back.