It can be a dresser, a cabinet, or some other piece of similar furniture. When the necessity to remove drawers arises, you must avoid being forced to deal with illogical situations. It's usually not too difficult to cope with a situation where you have to remove a drawer with full extension slides or under mount drawer slides. On the other hand, removing some drawers can be difficult. When the drawers, for instance, use metal glides rather than levers. Therefore, it can be challenging to remove the drawers because you might not be aware of the locking mechanism. Of course, finding a solution is not impossible. Let's discuss it and learn how to take out drawers that have metal glides but no levers. There are numerous techniques that apply to these circumstances. I'll start with the most typical scenario. A screwdriver and sufficiently thick work gloves are required.
Removing Drawers With Metal Glides And No Levers But Plastic Stops
There should be a different stopping and releasing mechanism in place of the lever, which is typically a plastic stop. There are now numerous varieties of plastic stops. The typical type strays on the side or far rear of the drawer and resembles a little tab. Due to these stops, whenever you attempt to open the drawer, it will only move a certain amount before emerging into your hands. The worst case scenario fails and causes an accident. These are essentially the mechanisms that prevent your drawer from being removed, thus we must turn them off before carefully removing the drawer. A screwdriver is required to either slightly loosen the stop or to simply remove it. If you're unsure as to whether the drawer genuinely has a plastic stop, you could try opening it all the way to make sure. The ones with built-in stops in metal glides are the ones that stop after 3/4 of the way. Once you are certain about it, take the following actions:
- Make the drawer empty all the way. To make it compact and manageable, you want to remove all of its contents. While a half full drawer is OK, it is still preferable to handle items with an empty drawer.
- You should start with the top drawer if it is a cabinet or dresser. Move downward systematically and gradually. This will prevent any concerns with tipping or imbalance.
- Stopping won't allow at some point while you try to remove the drawer. It is never advisable to use force there. That would only break the halt, and since you would be utilizing it again, it is definitely not acceptable.
- Here, the major goal is to try and separate that stop from the component that is essentially preventing removal. You should very softly and incrementally raise the drawer. Try raising the drawer front a few inches after that. In order for the box to pivot adequately. The stop can also be slightly lowered. Additionally, it makes it simple to clean the cabinet face.
- One of your hands ought to be positioned behind the drawer's back. Consequently, you can support it while gently tugging it. Once the stop has cleared the facing, you can remove the drawer completely. You can just reach forward and place both of your hands on the drawer's sides. The drawer should come out of the cabinet easily if you try to lift it as you normally would.
Useful Tip
A small bit of lift and pull motion is required with metal slides, which essentially slide using plastic-made wheels. The wheels would be made to travel through a curved segment. Gliders' very back should have this. After that, try pulling it while elevating the front side. With a little wriggling, you should be able to easily remove the drawer.
Considerations Before Removing Your Drawers
- Wear Close Toed Shoes
This is particularly crucial if you are moving a large piece of furniture. It could not be a good day if the drawer spills and hits your foot. Additionally, your furniture may fall over if it is not fastened to the wall. - Empty The Drawer Completely
Everything inside the drawer you want to remove should be taken out. Clear out each drawer and any items from the top of the dresser before you remove it's individual drawers. Make sure there are no blades or other sharp objects in kitchen drawers that might fall to the ground during removal. - Start At The Top
If you only need to take out one drawer for replacement or repair, you can ignore this. However, if you are emptying every drawer, always begin with the topmost drawer. By the time you reach the very top drawer, starting at the bottom runs the risk of making your furniture top heavy. There may be a tipping point here.