How To Put In A Fence Post Spike: The Best Way To Install A Fence Post Spike

The Best Way To Install A Fence Post Spike

Checking the location of any underground cables and pipes with a detector is the first and possibly most crucial step you must take so that you can avoid them while setting up your fence posts. Before beginning, we also strongly advise discussing any intended fence modifications with your neighbor and confirming your ability to enter their land. The task will be significantly simplified if you can work on the fence from both your garden and your neighbor's garden. Finally, you must choose the type of post support that will be used for your fence. Fence post spikes are ideal if your fence will be built on solid ground; however, if this isn't the case, you should also think about utilizing concrete-in post supports, although this will need some digging. Below are instructions for each, depending on which one you require.

Step 1: Trace The Location Of Your Fence

Use a line of string to trace the location of your fence. Then, place the fence panels and posts next to the line, marking the locations of the post spikes or concrete-in post supports with a colored marker spray.

Step 2: Drive Your Post Spikes Into The Locations

Use a driving tool and sledge hammer to drive your post spikes into the locations that you previously designated with your spray if you're using one. Alternately, if you're utilizing a concrete-in post support, you must insert it into a 450mm cube of concrete. As you do so, make sure you regularly check the alignment.

Step 3: Drive The Posts Into The Spikes

Now that the wooden fence posts have post spikes, it is time to drive the posts into the spikes. The posts must next be secured completely by screwing them into the spikes to complete the process. On the other hand, if you are using concrete-in post supports, you simply need to wait until the concrete is fully dry before inserting your wooden fence posts.

Step 4: Start Adding The Fence Panels

Now that the posts are in place, you can begin to add the fence panels. As you build your fence, be careful to periodically check that each post is vertical. You can do this quickly and easily by using a post level. Making sure your fence does not touch the ground at this time is crucial since doing so can cause the panels to deteriorate. Make sure there is a gap of at least 100mm under each panel to prevent this from happening. The posts' bases can alternatively be secured with treated gravel boards that you can screw into place. Additionally, they will prevent any decaying and ensure that the fence panels are raised above the ground.

Step 5: Screw In Two Or Three Stainless Steel U-shaped Post Clips

It's time to screw in two or three stainless steel U-shaped post clips to each fence post, securing them as firmly as you can. You can start slotting in each of your fence panels after you have added all the post clips.

Step 6: Fasten Your Fence Panels Into Position

Last but not least, be sure to seal the deal by fastening your fence panels into position by driving screws through the post clips. This will assure their durability and ability to tolerate windier conditions. You don't want all of your effort to be in vain!

Now that your brand-new fence is complete, why not think about covering the top of each post with a post cap? This gives the post a more polished appearance while also assisting in weather protection. You might also think about adding a trellis to the top of the fence, which will serve as an additional security deterrent in addition to being lovely when paired with lovely plants and flowers.