Ultimate Step By Step Guide Of Painting Shutters With A Brush
Painting the shutters is often one of the jobs that are impossible to ignore for a long time. The actual job is easier than it appears. Only with some of the preparation work and only a few simple techniques, those shutters will easily look shiny and brand new. Ultimate step by step guide of painting shutters with a brush is mentioned below:
Step 1: Clean The Shutters
- When painting the shutters, the first step must be cleaning them. In case, of the wood shutters, use a scraper to remove all of the old layers of paint if there is any.
- Then use the fine-grit sandpaper to smooth out any of the bumps or the lumps that are on the shutter. This step is important in order for the new paint to adhere well and will look very glossy.
- For the vinyl shutters, simply use a broom to wipe away all the cobwebs. Then take a damp rag to wipe down all the dust as well as the dirt.
- If there are any patches of mold or the mildew, then the users need to tackle that before the paint. If there is any then mix one part of the bleach with the four parts of water. Keep it into a spray bottle and then soak down the moldy area. Then rinse clean with the help of a hose.
- The next step is to scrub down the shutters with the help of soapy water and the soft-bristle brush. This will help to remove all the hardened dirt as well as chalking. Leave the shutters to air dry before beginning the painting job.
Step 2: Primer
- It is a good idea to prime the shutters first. This will help the paint to adhere on to any unpainted areas strongly and will also offer better coverage.
- If the vinyl shutters don’t have any peeling but they are just faded, then there is no need for a primer. With wood shutters, there will be power wash or scrapping the shutters until there are no blistering or peeling on the areas left.
- If in case the primer is needed then it is recommended to use a specific bonding primer. This will help the top-coat adhere properly.
Step 3: Use An Angled Brush
- The First step is to tape off all the surrounding areas to avoid getting the paint on other parts of the exterior.
- Then take an angled sash brush for painting in between the slats. Start the job with a light coat of paint and let it dry.
- The shutters at least need two coats of the paint for each of the shutters. Working in light and thin layers will help to prevent the paint from becoming the globs right in the corners of the shutters.
- During another application, do the touch-ups. Look for any of the crevices that might have been missed.
- If accidentally the user gets the paint on the trim or on the siding, then simply wipe it away with the help of a damp cloth. If there are the paint spots after the paint has completely dried, then use rubbing alcohol that will take care of it.