2 Easy Parts With Steps To Paint The Bathroom Cabinets
In order to paint your bathroom cabinets and make them look attractive and amazing, the users simply need to follow the 2 easy parts with steps that are mentioned below. Follow both parts carefully in order to achieve desired result:
Part 1: Sanding And Priming The Cabinets
- Clean: The first step in this process is to clean the cabinets using trisodium phosphate (TSP) and water but make sure to put on gloves before using this solution. Simply dip a sponge in the TSP solution, wring out the excess solution, and wipe down each cabinet inside as well as outside. After that wipe down each cabinet with the help of clean cloth so that any excess residue is removed.
- Doors And Hardware: After wiping the area, next step is to remove all the hardware and doors, try to pull out drawers and pop off all false drawer plates as well. This will help the user to work smoothly without any obstruction. It's advisable to store all the hardware in the bag so that it can be easily traced after finishing the job.
- Sanding: Sanding is important step in painting the bathroom cabinets, it will remove all the existing paint, use high-grit sandpaper and start sanding from outside of the doors, panels, and baseboard. The user is not required to remove all the traces of the finish, instead just make outer surfaces of cabinets coarse enough so that the primer adhere to it strongly. The user should work out for any rough edges and aim for a smooth finish. The user should sand the area in a smooth circular motion. Try to run the sandpaper as straight as possible along all the edges and narrow panels. Once the sanding is done then clean all the debris or dust with a cloth or a Shop-Vac.
- Apply The Primer: Now its time to apply the basic coat of the primer to all the areas where the paint job is needed, apply the primer in the thin and even coat. One of the important points is that Primers should be formulated for use with the type of paint that the user is going to use for instance Water-based primers should be used only with water-based paints. After the primer is done let it dry then again lightly sand the area so that the surface area will be uniform.
- Painter’s Tape: Now to mask the underside and inner edges of the cabinet apply the masking tape. Also, apply the painter's tape to the area where the cabinet meets the wall. The user should also mask the counter tops as well. In order to avoid the glaring mistakes, the tape should be straight and even.
Part 2: Applying The Paint:
- Mix The Paint: Before applying the paint it's very important to mix the paint well so that any free of clumps or separation is removed. To mix the paint the user can use an electric drill which should have a paint paddle attachment this is important in case the paint is sitting for a while or simply gives it a stir with a stick if just bringing it home. The paint should be properly mixed so that it will give a smoother coverage.
- Apply The Base Coat: Now start applying the base coat, start by applying the paint to the cracks, crevices and other hard to reach spaces. Then Afterwards, apply the paint on the flat and broad surfaces using a dense foam roller. Let the first coat to dry for about a couple of hours then apply the subsequent coats.
- Additional Coats As Needed: For the seamless finish the cabinets needs 2 to 3 coats. For the last coat, the user should use a steady hand and a consistent brushing pattern. It's advisable to look for any drips as they can get permanently settle into the finish once it dries.
- Allow The Paint To Dry: Allow the paint to dry completely, it will take 24-48 hours for the paint, though the paint becomes resistant to scuffs and other marks within a week. Leave all the doors open to provide airflow.
- Doors And Hardware: Once the cabinet is completely dry then reassemble the doors, install all the hardware back into the right place.