5 Easy Steps Of Painting A Metal Bulkhead
Bulkhead is considered as one of the main parts at the exterior of your home, however, it is usually neglected or looked over by the majority of the homeowners. The Bulkhead wears away or changes the appearance or texture of the storm through rain, ice, snow, heat, as well as cold by long exposure to the cold temperatures in the morning & the blazing heat at the peak of the day. The change in temperature requires the correct preparation as well as the coatings to be applied, otherwise, almost instant failure will occur. The weather, in addition to the closeness to the ground and without maintenance ultimately results in rust and metal rot. At first, painting a metal bulkhead might seem to be a very difficult task, however, painting bulkheads are the same as painting any other surface. If you know the painting procedure of any other surface, then you can easily be able to paint a metal bulkhead. In order to paint a metal bulkhead, go through the below-mentioned easy & simple steps carefully:
- Remove Already Existing Paint: First of all, remove the already existing paint, if any, from the metal bulkhead, by spreading a layer of paint thinner to the painted areas and then let it soak for nearly one minute before scrubbing the paint with the help of a wire brush. It is important to look over any bolts or rivets for small chips of paint on every side of the edges.
- Scrubbing: Rub the metal bulkhead hard, so as to clean them, typically with the help of a metal brush. This will help roughen the surface of the metal as well as helps with the primer application.
- Apply Primer: Now, it is time to prime your surface using two layers of primer. Before you apply the second layer of primer, make sure that the first primer layer is entirely dry. This will help in protecting the metal surface from possible corrosion from the paint.
- Painting: Apply the first coat of particularly designed metal paint to the metal bulkhead. Be extra cautious while painting over bolts, nuts or screws. Painting over any dowels is fine. Wear a surgical mask as well as eye protection in order to keep yourself well protected from paint fumes and potential blowback while painting.
- Allow The Paint To Dry: Finally, dry the first coat of paint before applying the second coat. This layer is very useful in balancing out the colors as well as protect any bare spots on the bulkhead. Again, wear a protective mask as well as eye protection when painting. Give few hours for the paint to dry. If needed, apply a third coat.