Two Easy Methods For Making A Table Taller
Raising the table can be a simple task if the right tools are used. There are a number of different ways used to increase the height of the table, the best and simple methods are mentioned below:
Method 1: Extensions
- Bed Risers: To make the table taller quickly, the user needs to purchase bed risers to place under the table legs. Bed risers are available in wood and plastic material, in different sizes as well as shapes. The user needs to be sure to purchase a set of risers which will support the weight of the table.
- Attach Bun: The other option to raise the height of the table is to add the bun feet to the bottom of a wooden table. Simply purchase 4 bun feet having pre-installed hanger bolts from the local hardware store. Drill the holes deep into the bottom of each table legs, then hammer it in tee nuts. At last, screw the bun feet until they are tightly attached and the table should not wobble.
- PVC Pipe: PVC pipe is best suited to the metal table, for that purchase PVC pipe with a diameter of 2 inches from any local hardware store. After that cut out the PVC pipe into 4 equal pieces to the height that the user wants to add to the table. Turn the table onto its side and secure the PVC pipe over each foot, then stand the chair up carefully.
Method 2: Wooden Extensions To The Table Legs
- Wood Pieces: Under this method the first step is to purchase the wood pieces from the local hardware store, these pieces will help to extend the table legs height. Look for pieces that should be rough of the same width as well as the same type of wood used in table legs. The users are advised to purchase the unfinished wood pieces or made table legs that can saw as needed.
- Make The Center Of Each Leg: Flip the table upside down and place the table face on the ground. With the help of a ruler, measure out the center point of every table leg. Mark the center spot using a pencil.
- Drill Holes: Using an electric drill make a hole that should be approximately 0.25 inches deep at the bottom of each table leg where the center was marked. After that, insert the back of the tee nuts in the drilled holes. With the help of a hammer gently secure the tee nuts into the wood. It's important to remember that the surface of each hammer tee nut must be flush with the wood surface.
- Insert Hanger Bolts: After the above step is done then insert the hanger bolts. The hanger bolts are important screws having bolts on the end of them. The user needs to measure as well as mark the center of each wooden extension. Drill in a hole on each piece that should be roughly half of the length of hanger bolts, after that insert the screw part of the bolts in the wood.
- Attach Each Leg Extension Firmly: Carefully secure the bolts of each wooden extension into the hammer tee nut on each of the legs. Continue the screwing process until the user will get the resistance to ensure that they are tightly attached. At last, flip the table to test its evenly on the ground.