Step By Step Process Of Making A Cocktail Table
Before going to build a cocktail table, the users need to make sure that they choose the quality lumber, like pine, cedar, or redwood. Moreover, the slats must be in good condition as well as perfectly straight. In order to build a cocktail table, the users need to go through all the mentioned steps carefully and achieve the desired result of their task:
- The first step of this job is to build the frame for the cocktail table. In this plan, the users are recommended to build the components out of the 2×2 lumber. It is important to take accurate measurements before adjusting out the size of all the components to the exact dimensions. Drill-in several numbers of the pilot holes into the wooden components before screwing the galvanized screws.
- The next step of the project is to build the slats simply by cutting at the exact size and then to lock them to the supports. Drill-in the pilot holes at both the ends of the slats right before inserting the screws, this will help to prevent the wood from getting split. Smooth out the cut edges with the help of fine-grit sandpaper before securing them to the place. Add the waterproof glue to the joints, if the user wants to make a rigid frame for the tabletop.
- Attaching all the supports with the top of the frame is simply a straight-forward task, but the user will still need to pay the attention to a number of aspects. Therefore, it is advisable to cut out the ends of the support in a decorative manner and also check if they are at the proper level, with the help of a spirit level.
- One of the last steps is to secure the tabletop with the supports and then lock them into place with the help of screws. In order to get this done in a professional manner, it is advisable to place the slats on a properly leveled surface, mark down the cut line, and then take a jigsaw to get the job done. Lay down the frame right on top of the slats. Drill-in the pocket holes into the supports as well as insert 2 1/2? screws in the slats. Add the waterproof glue to the joints, if needed.
- Finally the user needs to take care of the finishing touches. Therefore, fill all the pilot holes with the help of wood putty and then smooth the surface using the 120-grit sandpaper. In order to seal and protect the lumber from the water damage, cover all the components with the several coats of paint. Position the cocktail table in a proper location and then move it whenever required.