Proper Procedure Of Making A Beveled Edge On Wood
To give a piece of wood's apparently ordinary square edge some aesthetic appeal, bevel the edge. You may adorn a table, cutting board, or any piece of square-edged wood with a range of distinct bevel kinds made with a widely accessible router. When using a router, make sure you are using safety glasses. When it comes to the equipment used to bevel your wood, there are a few things you should be aware of. When making bevels in your Woodstock, you should always select the appropriate tools and technique. To get the results you want, choosing a bevel method requires careful consideration.
Things You'll Need
- Router
- Router Bits
- Adjustable Wrench
- Sandpaper
Step 1: Select The Appropriate Bit
To make the desired bevel design, choose the correct bit. Keep in mind that the bit creates a bevel that is counter to its contour. To avoid mistakes, pick a bit with an integrated guiding bearing.
Step 2: Put The Router Bit In Place
Put the router bit in place. Use an insert if you are using a 1/4-inch shaft bit, and put the bit shaft into the collet sleeve in the router's middle. Completely enclose the bit's shaft in the collet. Before using an adjustable wrench to tighten the retaining nut, pull it out 1/4 of the length of the shaft.
Step 3: Avoid Cutting The Wood With A Jointer, Circular Saw, Or Table Saw
Check that the wood is securely braced or clamped in place and that the edge that has to be beveled is square and well-cut. If not, avoid cutting it with a jointer, circular saw, or table saw.
Step 4: Start The Router & Take Note Of The Direction The Bit Is Turning
Start the router, and see which way the bit is rotating. Contrary to the direction the bit is turning, cut into the wood in that direction. Push the bit as well as bearing against the edge you want to bevel while maintaining solid contact with the router's base against the wood's flat edge.
Step 5: Push The Router Along Its Edge
To create a bevel along the length of the piece of wood, push the router along its edge. To guarantee that the bevel extends all the way to the edge, continue running the router past the piece's end without pausing. If desired, begin a new edge in the same way as in Steps 4 and 5. Use 440 grit sandpaper to smooth off the completed edge.
Tip & Warning
- In order to prevent burning the wood or harming the bit, lower the bit's cutting edge carefully from the guide plate while cutting a very deep bevel.
- When using power tools, always wear the proper eye protection.
What Tool Make Beveled Edges On Wood?
- Circular Saw
Utilizing a circular saw is one of the best options when it comes to finishing a bevel cut. In other terms, a circular saw is operated manually by hand. Due to this, your bevel cut might not be as accurate or perfect as it would be with a table saw. In order to maintain the blade moving straight, this is done using a high-quality woodworking square. In order for the blade to cut through the wood at an angle, it must also be inclined. You should be aware that a circular saw can be used to complete a beveled crosscut. - Chop Saw (Miter Saw)
You may also make a beveled cut in a piece of wood using a chop saw, sometimes referred to as a miter saw, which is a piece of woodworking equipment. With a piece of wood that is resting on the saw's flat surface, you are ready to tilt the blade into the proper angle. The desired bevel cut is then achieved by the worker pulling the blade through the wood. Only cross cuts, not rip cuts, may be made with chop saws and miter saws.