How To Install Vinyl Fence On Concrete: Proper Procedure Of Installing Vinyl Fence On Concrete

Proper Procedure Of Installing Vinyl Fence On Concrete

Having a fence around your property can help you define it, boost your privacy, and provide your children and animals with a secure area to play. When it comes to materials, you now have more alternatives than ever. A great substitute for conventional wood or chain-link fencing is vinyl. It is appealing, strong, and practically maintenance-free. There is also no need to be concerned about decay, corrosion, or water damage. In addition, setting up a vinyl fence is a DIY undertaking. Any sort of fence installation may be time-consuming, and vinyl fence installation is no exception. Setting the posts appropriately presents the biggest obstacle during vinyl fence installation. They need to be level, correctly spaced, and positioned in a straight line to maintain the integrity of your new fence. After everything is finished, installing the vinyl panels is not too difficult.

Step 1: Select A Fence That Will Meet Local Code Requirements

Choose a fence for yards with pools that will adhere to local building codes. Be cautious to check with your local authority as these fences frequently need to be 4 feet tall and must meet picket spacing specifications. Make sure to contact regional utility location firms as well. These services are offered without charge, and they'll make sure that before you dig, you're aware of any subterranean facilities like electric, gas, water, or sewer.

Step 2: Mark The Location Of Each Of The Post Holes

Place stakes in the ground at each corner of where the fence will be, then connect them with a string line. Mark each post hole according to the manufacturer's suggested spacing using a tape measure and landscape paint. To dig the posts' holes, use a post hole digger. Consult your local codes as frost lines might vary from area to region since the holes must be deeper than the frost line. To determine the depth of the hole, use a tape measure.

Step 3: Fill The Hole With The Concrete

After excavating each hole, mix the concrete mix in a wheelbarrow, then pour the concrete into each hole to a depth of about two feet. Use a level to check that the vinyl fence post is plumb from front to back and side to side before sliding it into the wet concrete. Verify that the mortises are pointing at each other and not at the yard. Use the rubber mallet to adjust the post's height so that the bottom of the mortise is just slightly above the ground before the post has fully hardened. Backfill the remaining portion of the hole when satisfied. Before proceeding to the following step, let the cement to dry for a day or two.

Step 4: Install The Rails First And Then The Clips

Metal rails are sometimes used in vinyl fence systems to strengthen the bottom rail and clips to keep the rails in place. If that's the case, slide the bottom rail assemblies into the post mortises after installing the rails and then the clips. The side strips should be screwed into each post using a screw gun. Starting at the mortise in the top of the bottom rail, plumb the strip using the level.

Step 5: Install Pickets Between The Rails

Put pickets in the spaces between the rails. Consult local code enforcement before installing spaced pickets as certain areas need particular spacing. Concerning cutting the pickets to a precise angle, don't bother unless the fence is erecting along an extremely steep hill. The staggered board ends will be concealed by the mortises in the top and bottom rails. Pickets may need to have the top and bottom chopped off in order to follow steep hills. While it need not be exact, it should be close enough for the rails to cover any gaps.

Step 6: Slide The Top Rail Into The Mortises In Each Post

Insert the top rail into the mortises in each post and slide it over the pickets. Drive a screw into the top rail from the inside of the post to prevent it from moving and coming free. To prevent rain and bugs from gathering on the posts, cap them last.