5 Easy Steps Of Installing Trafficmaster Glueless Laminate Flooring
A glueless laminate floor is considered one of the easiest as well as the most flexible & adaptable types of flooring that you can lay. The main purpose of laying the glueless laminate flooring is that the laminated boards of the flooring connect or join together, however, they are not secured to the house in any way, instead, they are just attached or fastened with pins underneath the floor trim at the edges. Glueless laminate flooring can run over any type of flooring type of material excluding carpet material. One of the best brands or types of glueless laminate flooring is Trafficmaster which is popularly known for its affordability as well as durability. Therefore, if you are looking to install laminate flooring at your home, then it is highly recommended to install Trafficmaster glueless laminate flooring. Go through the below-mentioned steps carefully & install the Trafficmaster glueless laminate flooring:
- Remove The Floor Trim: First of all, you need to get rid of the floor trim with the help of a prybar and hammer. Make sure not to damage or impair it in any way, as you remove it so that you can use it again.
- Lay Out Your Underlayment: The next step is to set up & arrange your underlayment in the course through or on top of the whole floor, starting along one wall. Trim it as needed with the help of a utility knife. Tape the courses at the same time through their edges using plastic flooring tape.
- The First Course Of Trafficmaster Floorboards: After that, place the first course of Trafficmaster floorboards through one wall, in such a way that the grooved sides of the floorboards are positioned towards the wall. Keep half an inch of space at the wall, which will be very helpful in allowing the floor to expand with environmental changes. Connect or join the boards at their ends, trimming the last one in order to fit in opposition to the perpendicular wall.
- Go Course By Course: Then, put, lay, or stand the next courses in place, connecting or joining the boards along their sides. Go course by course through the floor, due to the fact that the ends don't line up. You will find Trafficmaster flooring in a huge range & different board lengths, which will help you with this. Trim the end pieces, as needed, on your miter saw.
- Set Your Floor Trim Back In Place: Finally, trim the final course of boards through their lengths with the help of a table saw, so that it leaves a half-inch gap there. Put, lay, or stand your floor trim back in place in order to make sure that it covers up the gaps, securing it with the help of a trim-nailer.