How To Install The Top Piece Of Vinyl Siding: Easy Process Of Installing The Top Piece Of Vinyl Siding

Easy Process Of Installing The Top Piece Of Vinyl Siding

Installation of the top piece of vinyl siding calls for special caution. If it is not properly fastened, it could potentially come loose and be susceptible to flapping in a high wind. Once you understand how to install the best vinyl siding, you can be sure that your house will continue to be weatherproof. As you affixed the siding to the external walls during installation, hopefully, you were nailing in the middle of the holes. Vinyl siding expands and contracts in hot and cold weather, so this is important. The siding material can move slightly without buckling thanks to nails in the center of the perforations. This principle also applies to the installation of the undersill trim. Utility trim is yet another name for undersill trim. When learning how to install the top piece of vinyl siding, you'll also require it.

Fasten Next-to-last Row Of Vinyl Siding

Your next-to-last row of vinyl siding should be properly fastened to the area beneath it. Aim to place nails in the center of each hole as you nail the edge. Install undersill trim against the soffit along the top of the wall. The second-to-last siding row's top lip is where you should measure from the soffit.

Take Multiple Measurements Between The Soffit & Top Siding Lip

Take a quarter-inch out of this measurement. To check for variations, take several measurements between the top siding lip and the soffit. Every soffit does not meet the wall and siding in a straight line. To ensure a perfect fit, you might need to cut the top piece of siding at an angle. Use a table saw to cut the vinyl siding after calculating its exact width. So that you still have a siding edge to snap into the lower row of the siding, cut the nailing edge side.

Use The Snap Lock Punch To Puncture The Cut Edge Of The Top Siding Piece

Use the snap lock punch at this point. When learning how to install the top piece of vinyl siding, this is a crucial step. You can use a hand tool called a snap lock punch to make a hole in the top siding piece's cut edge. It produces ridges that will fit snugly inside the undersill trim's groove. Using the snap lock punch, grasp the top siding piece's cut edge. Squeeze the punch until an exposed edge is formed after it has pierced the vinyl.

Punch The Whole Length Of The Siding Material Every 6 To 12 Inches

Every 6 to 12 inches, punch the siding material throughout its whole length. Position the siding component. Insert the notched edge into the undersill trim's groove. Place the vinyl siding's bottom edge on the lower row's edge.

Try Sliding The Newly Installed Vinyl Siding Section Back And Forth

Make certain you notice and feel the joint closing. Otherwise, a strong wind will cause the siding to come loose. Slide the strip of vinyl siding that was recently installed back and forth. It ought to move a little. This shows that it is capable of coping with the expansion and contraction brought on by temperature fluctuations.