Hollow Metal Door Frame Installation Process
Steel doors typically come with a steel frame as well, giving you greater security for utility and garage rooms than wood doors. Steel frames typically come with metal tabs that attach to the edges of the jack studs framing the doorway because the metal is thick and difficult to drill through. A steel door frame can be put in either before or after the wall is framed. If the floor isn't level, installing a steel door frame can sometimes be simpler because the base-securing tabs are still reachable and can be adjusted or shimmered. If you have all the necessary materials on hand and are familiar with the installation process, hollow metal doors can be fitted in approximately 15 minutes. When the walls are being framed, metal frames are placed. The studs around the door frame are cut and placed once the door frame has been fixed.
Step 1: Preparing To Install A Metal Door Frame
- Preparation is one of the most crucial steps in learning how to install things on your own. Starting a project with little planning and the incorrect equipment is a definite way to cause chaos.
- Make sure your current frame is correct first. You need to be aware of any issues, the level of the installed frame, and any idiosyncrasies you might need to take into account. You're entering a situation oblivious to one that might rapidly turn bad if you don't take a long, hard look at your current situation.
- To install the new steel door or metal frame, you will first need to remove the old frame from this position. Remove the inside and exterior moldings, as well as the door itself.
Step 2: Install The Door Clips
- Put three door clips on each of the legs to start. These clips ought to be included with the frame you bought, and it ought to be clear where they go and which way they face.
- The top clips ought to be between 10 and 12 inches below the top. Keep the bottom clips just high enough to avoid getting in the way of the drill, and the middle ones level with the strike.
Step 3: Attach A Magnetic Level
- Next, position your level across the door frame aperture. It would be beneficial if you identified the high side because, in any circumstance, you want to anchor on that side first. Check to see if the door clips are securely fastened.
- Place your frame in the opening at this point. Your top clip should be flexible enough to temporarily keep the frame in the opening.
- Put your spreader in the door aperture after securing the high side with temporary spreaders. Fix the frame head with the magnetic level.
- At this point, you must fiddle with shims to level the frame. It's a challenging aspect of installing any frame, but it's crucial if you want the results to work well and look well.
- Comparing the installation of a wooden and a metal door frame Make sure the industrial metal door frames are properly level throughout the entire process because it is much harder to change them after installation.
Step 4: Drill Holes
- It's time to grab your drill right now. Each hole should be made on a floor plate. We advise utilizing pins that are one-quarter to three-quarters of an inch long and a quarter-inch masonry bit.
- Use your hammer to ensure that these pins are securely fastened. While drilling and hammering, keep in mind that the door frame needs to remain centered.
- Use some washers to solve the issue if your holes are bigger than the available screw heads.
Step 5: Slide The Studs On
- You must next slide metal studs onto each side of the door frame to complete the door installation process. The clips will be up against these studs. Maintain the frame's balance. Place two self-tapping screws into the high-up clips, then clamp the studs to them.
Step 6: Add Remaining Clips
- Clamp the remaining clips to the remaining studs after installing the top clips. A half-inch tapping screw is required for each door clip.
- You should be prepared to add your new door and leave the frame in place at this point. Of course, we always advise reading the instructions that come with the frames and doors you buy because they can contain particular guidance that you need to take into account.