How To Install Crown Molding For Staggered Cabinets: Easy Process Of Installing Molding On Staggered Cabinets

Easy Process Of Installing Crown Molding On Staggered Cabinets

You can occasionally install the Kitchen upper cabinets easily at two heights or different depths if you are looking to create a focus of attention or add drama to the kitchen. Typically, the taller or forward cabinets are in the center adjoining by shorter cabinets & they are usually known as staggered height cabinets. The majority of the homeowners like the look of crown molding through the top edge of the cabinet face in order to finish off the appearance of the cabinets. The process of installing the crown molding does not change if you are having staggered cabinets, as the process is the same for every type of cabinet.

Step 1: Measure The Width Of The Tall Cabinet

First of all, calculate or compute the width of the forward or tall cabinet. Take a miter saw & turn the molding upside-down in order to make sure that the fence of the saw is the face of the cabinet & the base of the saw is the ceiling.

Step 2: Make Your First Cut

Now, place the arm of the miter saw to the left on the 45-degree line. Move the molding smoothly to the right in order to make sure that you can trim near the left end. Take hold of the molding flat to the fence as well as the base and make your first cut.

Step 3: Make Your Second Cut

Calculate from the cut to the right before marking your width measurement. Move the molding smoothly to the left. Move the arm of the miter saw to the right before placing the arm on the 45-degree line. Align the blade using your mark. Take hold of the molding flat to the fence as well as the base and make your second cut. Turn the molding right-side-up before fitting it to the top edge of your cabinet. Put the molding to one side.

Step 4: Make The Straight Cut

Now, calculate from the back edge of the cabinet to the left front corner. Place the arm of the saw to the center and 90-degree line. Move the molding smoothly to the left before making the straight cut. Next, calculate from the cut edge before marking your next cut. Position the arm to the right 45-degree line. Line up your mark using the blade. Take hold of the molding to the fence as well as the base and make your second cut. Turn the molding right-side-up before fitting it to the first cut piece. You will have an accurately mitered outside corner. Repeat the same process for the second side piece with the opposite angle cut.

Step 5: Secure The Molding To The Cabinet

Secure the molding to the top edge of the cabinet with the help of finish nails as well as a nail gun. Keep your nails separate eight inches from each other. Take hold of the corner together and drill two small pilot holes across the end of one cut corner into the end of the second cut corner. Use carpenter's glue along the inside face of the corner cut edges before pressing the corners together well. Tap two 4d finish nails along the pilot holes at the corner joint.

Step 6: Apply Coping Technique

Cut inside corners by applying a coping technique. When two pieces of crown molding overlap at an inside corner, then the first piece is trimmed to 90-degrees. Trim the second piece at a 45-degree angle. It will not fit, so, draw a line around the outside cut edge in order to make it easy to see. Use a pencil & cut along the drawn line with the help of a coping saw. Front-view and full-size from the miter cut by 25-degrees. Place the cut crown molding over the first molding again. It will fit and appear like a mitered corner. Use this technique also for your inside corners.