Easy Process To Bullnose Corners Of Drywall Around Windows
Bullnose for drywall is usually put together or produced in metal, vinyl, as well as paper-faced beads. The trim offers another possibility or choice to the square outside corners by undermining the resistance of the finished look. Generally, metal bullnose is used in merchandising construction, vinyl in homes, as well as paper-faced when doing patchwork. Irrespective of the type, installation is more reliable when you use staples rather than adhesive or setting the beads in drywall mud. You can easily bullnose drywall corners around windows within a short period of time. In order to install bullnose corner beads around windows, go through the below-mentioned step by step process carefully:
- Measure The Distance
First of all, calculate or compute the distance betwixt the inside faces of drywall at the top as well as the bottom of the window opening. Mark two pieces of bullnose to length with the help of a pencil before cutting them with the help of sheet-metal scissors. - Set Up Staple Gun Using 1/2-inch Staples
Now, place or erect a staple gun in a position with the help of 1/2-inch staples. Secure or affix the pieces at the outside corners at the top as well as the bottom of the opening using staples every 3 inches along with the flat bands of the beads. - Mark & Cut A Piece Of Bullnose
The next step is to calculate or compute the distance at one side of the window opening betwixt the rounded portions of the upper and lower beads. Mark as well as trim a piece of bullnose to this length. - Cut The Angles Using Sheet-metal Scissors
Now, mark a 45-degree angle at each end of the piece with the help of a pencil. The angles are toward each other, exactly the same as one side of a picture frame, and the angle is not critical. Non-specific corners are filled with drywall mud. Trim the angles with the help of sheet-metal scissors. - Fit The Piece In Place
Finally, adjust the piece in place at the side of the window opening using the miter cuts on top of the rounded beads of the upper as well as lower pieces. Staple the bands of the piece, in exactly the same way as you did before. Repeat this process before installing the mitered piece on the opposite side of the opening.