5 Easy Steps Of Installing A Transition Strips On Uneven Floors
Transition strips are the types of strips that are mostly used to finish hardwood as well as laminate floor edges where the product joins or connects an existing floor in a doorway. These strips are generally trimmed to fit and then nailed in place or snapped into a track that has been secured with screws to the floor. Installing any type of flooring can be time-consuming as well as frustrating. The majority of the homeowners will come across the problem after the flooring is installed. The new flooring is usually higher in comparison to the floor in an adjoining room. The uneven floors can make people remain on their toes on these surfaces. A transition strip is a simple piece of wood or metal that can fill the gap betwixt two uneven floors. Installing a transition strip is an easy task that will only take an hour or so. Go through the below-mentioned steps carefully in order to install transition strips on the uneven floor:
- Determine Height Difference: Firstly, you need to calculate or estimate the height difference betwixt the two different floors. Grasp a measuring tape in opposition to the lower floor and compare it with the higher floor. Note down this measurement.
- Determine The Width: Now, ascertain or establish the width of the doorway or transition area and take note of this measurement as well.
- Buy A Transition Strip: After that, you need to buy a suitable transition strip for the area. A "step-down" transition strip is recommended, due to the fact that it fills the flooring difference in two uneven floors. This transition strip has an obtuse angle that slants up or down from the higher flooring surface to the lower floor.
- Mark The Transition's Width: Now, consider the measurement that you noted down in Step 2 & mark the transition's width using a pencil. Put down the wood transition strip on a miter saw and trim it to size if it's made of wood. If the transition strip is constructed of metal, trim it with the help of a hack saw.
- Secure The Transition Strip: Finally, secure the transition strip into place, using the screws. Pre-drill the holes with the help of a drill bit and drill. Affix the screws in place with the help of a screwdriver. If in case you are using a metal strip, you are finished. Finish a wood transition strip by padding or cushioning the nail holes in the strip using wood putty. Let the putty dry before smoothly sanding it using sandpaper. Paint or stain the transition strip, as per the choice of your color.