While preventing insects and other pests from entering your home, sliding screen doors make it simple to take in the views and sounds of outdoors. You must first measure your door frame and buy a door with the proper measurements if you intend to install a screen door to an existing sliding glass door on your porch or patio. Once the rollers are lined up with the track on the inside of the frame, installation is as easy as sliding the top of the door into the upper rail and raising the bottom up and over the lower rail.
Installing A Sliding Screen Door Back In Track
A fantastic way to let fresh air into your home while keeping bugs and other unwanted pests out is with sliding screen doors. They are a fantastic option for people who want to conserve space because they don't need as much space to open and close as traditional hinged doors do. The steps for installing sliding screen doors will be covered in this article. This guide will provide you all the knowledge you need to successfully install a sliding screen door in your home, regardless of your level of DIY experience. A screen door is simple to install for many do-it-yourselfers because they are lightweight and don't need to be secure.
Materials Needed
- Screen Door
- Circular Saw
- Sanding Block
- Drill
- Shims
- Pencil Or Marker
Step 1: Choose Your Door
You must decide what size door you require before making a sliding screen door purchase. To achieve this, measure the height and width of the interior of your outside door jamb. Traditional doors made of wood must occasionally be painted or stained. Often available in white or black, vinyl doors need less upkeep over time. Vinyl is a popular choice among homeowners due of its longevity.
Step 2: Fit Door In Opening
Make sure there is 3/16 inch on each side between the screen door and the door jamb. Shims can be used to secure your door and make sure it fits. If your door is too large, mark and cut off the overlapped door material with a straight edge and circular saw. With a sanding block, round the edge.
Step 3: Install Hinge
The majority of vinyl screen doors from stores come with reversible hardware. Installing your screen door on the same side as your outside door's hinges is recommended. Choose where your door hinges should be placed and note where the screws should go. Drill a pilot hole in each location you marked using a drill bit that is smaller than your screws. With the external screws supplied with your screen door packing, attach your hinges. With external and screen doors, always use exterior-rated hardware.
Step 4: Install Handle And Latch
While some screen doors already have handles attached, others let you decide where to place them. Verify that the replacement handle won't conflict with the one on your outer door. In accordance with the instructions included in the packing, mark and drill the holes for the handle and install the hardware. Allowing the screen door to close while positioning the latch against the handle mechanism can help you locate it correctly. Drill pilot holes using a tiny drill bit after marking the screw holes where the latch will be attached. If the handle and latch are functioning properly, attach the door latch and let the door open and close a few times. Finally, use screws to secure the hydraulic or spring screen door closing. You're prepared to say goodbye to the pests and hello to the breeze now that your screen door has been put correctly.