How To Hide Unbeveled Edges On Drywall: Instructions For Hiding Unbeveled Edges On Drywall


Step By Step Instructions For Hiding Unbeveled Edges On Drywall

Drywall occurs, happens, or takes place in 4-by-8-foot sheets, long edges being beveled while the ends are not. The bevel is a small impression or notch on the edge of the drywall. It makes finishing easier, due to the reason that it is deep enough to accept drywall tape as well as a layer of joint compound. You will sometimes need to turn sheets with one side facing forward during an installation and push unbeveled edges together. Hiding these edges can be very difficult, but it can be done if you are having moderate skills. You will get the best possible results by putting together careful drywall installation having proper finishing tools as well as techniques.
  1. Leave A 1/8-inch Gap Between Unbeveled Edges
    First of all, you need to maintain a 1/8-inch gap betwixt unbeveled edges, due to the fact that this will prevent the drywall from breaking. It will also help leave a void into which excess joint compounds can disappear.
  2. Secure The Drywall On Both Sides Of A Seam
    Now, securely attach the drywall on both sides of a seam to the stud beneath. You can attach the drywall using drywall screws or nails, however, you will have more control with screws. Make sure to position them 12 inches apart on walls & 8 inches apart on ceilings. Drive each one nearly 1/2 inch from the edge, and drop the head 1/16 inch below the surface of the paper.
  3. Run A Drywall Blade Over The Joint
    Next, move a drywall blade smoothly over the joint before taping it to scrape off any paper that is twisting & turning upward. Scrape off any paper from around screws that are nearby to the edges. Tape the joints with the help of paper tape and pre-mixed or powdered joint compound. If you use the powdered variety, combine or put it together as long as it is almost pourable. If pre-mixed, thin it using a little water in order to achieve a pourable consistency.
  4. Apply A Light Coat Of Joint Compound On The Joint
    Apply a light coat of joint compound on the joint with the help of a 10-inch drywall blade, before placing tape over it and scrape the tape flat. Immediately cover the joint by applying a second coat of joint compound, making sure to spread it the full width of the blade on any of the two sides of the joint. Scrape the joint, exerting pressure to the outside of the blade in order to feather that edge of the joint into the wall. The other side of the blade should be marginally raised in order to make sure it leaves a small ripple through the surface of the tape.
  5. Apply 2 To 3 More Coats Of Joint Compound
    Allow the first coat to dry fully before applying two to three more coats exactly the same way as you applied the first coat. Lastly, sand the final coat using 120-grit sandpaper before priming and painting the wall.
Connect with GetRit GetRit.com Furniture Facebook GetRit.com Furniture Twitter
Copyrights (©) 2024 GetRit.Com   All Rights Reserved