How To Glue Stainless Steel To Drywall: Instructions Of Gluing Stainless Steel To Drywall

Step By Step Instructions Of Gluing Stainless Steel To Drywall

Stainless steel is one of the most durable, corrosion-resistant materials that is used in a wide variety of home decor, such as wall paneling. Stainless steel offers a decorative option when it comes to kitchen backsplashes and walls, as well as a more durable & robust appearance in garages or workrooms. Stainless steel tiles, as well as panels, are fixed directly on top of drywall with the help of a construction-grade adhesive rather than traditional nails or screws. You can easily install stainless steel walls yourself without any difficulty in order to update your wall decor. Go through the below-mentioned steps carefully in order to glue stainless steel to drywall:

Place 1 To 2-foot Long Wooden Board Flush Against Top Of Drywall

First of all, walk to the wall where you are going to install the steel and position a 1 to 2-foot long wooden board flush in opposition to the top of the drywall. Pull the board down slowly, making sure to note any location where the wall bulges out or sinks back from the board. Mark these locations using a pencil, due to the fact that they need repair.

Apply The Compound Over All Of The Marked Wall Locations

Now, pull out the lid from a tub of joint compound before using a putty knife in order to scoop up 1/4 cup. Apply the compound over all of the marked wall locations in order to smooth them out with the remainder of the drywall. Pull the flat edge of the blade over the wall in order to get rid of the excess compound.

Sand The Drywall With Fine-grit Sandpaper

Wait as long as the joint compound dries before sanding the drywall with fine-grit sandpaper to smooth it. Wipe the wall from top to bottom with the help of a tack cloth in order to get rid of any sanding dust. Place, fit, or push a tube of construction adhesive in a caulk gun before cutting off the nozzle by 1/4 inch. Squeeze the trigger of the caulk gun 4 to 5 times in order to start the flow of the caulk.

Apply A Dime-size Amount Of Adhesive To Each Corner Of The Steel Tile

Now, turn the face of the stainless steel down on the floor before applying a dime-size amount of adhesive to each corner of the steel tile. When it comes to larger steel panels, spread a 1/4-inch bead thoroughly around the perimeter for added holding power.

Place The Stainless Steel Up To The Wall & Press It On Strongly

Position the stainless steel up to the wall before pressing it on rigidly and securely. Apply long strips of painter's tape over the steel before securing the ends of the tape to other areas of the drywall. The tape adds support as long as the adhesive dries.

Repeat The Process To Glue Any Extra Stainless Steel To The Drywall

Finally, repeat the process in order to glue any extra stainless steel to the drywall surface. Wait at least 24 hours, before removing all of the painter's tape. Peel off the clear protective facing Carefully from the front of the stainless steel.